Search results
Results from the WOW.Com Content Network
Motorola MOTOTRBO Repeater DR3000 with duplexer mounted in Flightcase, 100% Duty cycle up to 40 W output. A repeater is an automatic radio-relay station, usually located on a mountain top, tall building, or radio tower.
NHK digital television, KRY, TYS and YAB transmitter in Iwakuni. A broadcast relay station, also known as a satellite station, relay transmitter, broadcast translator (U.S.), re-broadcaster (Canada), repeater (two-way radio) or complementary station (Mexico), is a broadcast transmitter which repeats (or transponds) the signal of a radio or television station to an area not covered by the ...
The first relay system with radio repeaters, which really functioned, was that invented in 1899 by Emile Guarini-Foresio. [2] A radio repeater usually consists of a radio receiver connected to a radio transmitter. The received signal is amplified and retransmitted, often on another frequency, to provide coverage beyond the obstruction.
Repeaters are the lifeline of the ham radio operator. They are the towers that relay messages between ham radios, accepting the weak incoming signal and then transmitting it at a higher power, so ...
RFinder is the official repeater directory of the following associations: [4] Amateur Radio Society Italy [7] American Radio Relay League [1] Cayman Amateur Radio Society [8] Deutscher Amateur Radio Club [9] Federacion Mexicana de Radio Experimentadores [10] L’association Réseau des Émetteurs Français [11] Lietuvos Radijo Mėgėjų ...
An amateur radio repeater system consisting of a 70 cm repeater and a 2-meter digipeater and iGate. Coaxial cavity RF filter at 2 meter repeater An amateur radio repeater is an electronic device that receives a weak or low-level amateur radio signal and retransmits it at a higher level or higher power, so that the signal can cover longer ...
The station was affiliated with the American Radio Relay League, a national association for amateur radio, on Oct. 25, and had some high-level guests, “both in ham radio and science,” said ...
Common practice for 10-meter repeaters is to use a 100 kHz negative offset for repeater operation. Due to the very few available repeater channels, "odd-splits" (offsets differing from 100 kHz) and non-standard frequencies are rare and uncommon.