Search results
Results from the WOW.Com Content Network
Shaft mining or shaft sinking is the action of excavating a mine shaft from the top down, where there is initially no access to the bottom. [1] Shallow shafts , typically sunk for civil engineering projects, differ greatly in execution method from deep shafts, typically sunk for mining projects.
Shaft alignment is the process of aligning two or more shafts with each other to within a tolerated margin. The resulting fault if alignment is not achieved within the demanded specifications is shaft misalignment, which may be offset or angular. Faults can lead to premature wear and damage to systems.
USG once again declared bankruptcy on June 25, 2001, under Chapter 11 to manage the growing asbestos litigation costs. USG was the eighth company in an 18-month period that was forced to utilize Chapter 11 to resolve asbestos claims. In the prior two decades, 27 companies filed for protection under Chapter 11 because of asbestos litigation.
The tower served to support concrete chutes, pipes, booms, and other equipment necessary to install the piping, concrete, and steel linings. Workers then began to erect the steel liner and rebar incrementally so that they could pour concrete in stages. Concrete was poured continually and workers had to remove wooden shoring as concrete filled.
Since ground and ambient installation conditions as well as crew skills can affect the success or failure of a cure cycle, testing is performed by 3rd party laboratories in normal cases and should be requested by the owner. Samples should be representative of the installation environment since the liner is installed in the ground.
A simple labyrinth seal A labyrinth seal on a steam turbine shaft. A labyrinth seal is a type of mechanical seal that provides a tortuous path to help prevent leakage. An example of such a seal is sometimes found within an axle's bearing to help prevent the leakage of the oil lubricating the bearing.
The word 'boss' is also often used to describe the end of a shaft on a boat to which a propeller might attach. A boss may also refer to a mounting feature that will receive a screw or thread-forming screw. [3] In computer-aided design applications, a boss is a feature used to describe a type of extrusion.
Therefore, the part of the shaft in contact with the bearing slides over the bearing surface. The simplest example of a plain bearing is a shaft rotating in a hole. A simple linear bearing can be a pair of flat surfaces designed to allow motion; e.g., a drawer and the slides it rests on [3] or the ways on the bed of a lathe.