Ads
related to: jeep xj rear axle identification code chartquadratec.com has been visited by 10K+ users in the past month
Search results
Results from the WOW.Com Content Network
1984-1997 Jeep Wagoneer; 1984-2001 Jeep Cherokee; 1993-2004 Jeep Grand Cherokee; 1986-1992 Jeep Comanche; 1987-1995 Jeep YJ Wrangler Note: there was no 96 model. 1997-2006 Jeep TJ Wrangler *option Dana 44 rear and Rubicon's had Dana 44's; 2007 only some early Jeep JK 2 door Wranglers had Dana 35 non c-clip axles. 2001-2007 Jeep Liberty; Dodge ...
Vehicles made by American Motors Corporation (AMC) and Jeep incorporated a variety of transmissions and transfer case systems. This article covers transmissions used in the following vehicle models and years: All American Motors (AMC) passenger cars, 1954-1988; Jeep Cherokee XJ (1984–2001) Jeep Comanche (1986-1992) Jeep CJ (1976–1986)
The Jeep Cherokee (XJ) is a sport utility vehicle manufactured and marketed across a single generation by Jeep in the United States from 1983 (model year 1984) through 2001 — and globally through 2014. It was available in two- or four-door, five-passenger, front-engine, rear- or four-wheel drive configurations.
The Dana/Spicer Model 30 is an automotive axle manufactured by Dana Holding Corporation. It has been manufactured as a beam axle and independent suspension axle with several versions. 2011 Jeep Dana 30 differential Jeep Dana 30
The Dana 44 rear axle first saw use in the 1940s and is still in use today. The Dana 44 has a GAWR up to 3,500 lb (1,600 kg) and is a semi-floating type, having one bearing on the end of the axle shaft which carries the weight of the vehicle on the axle and also allows axle rotation.
The clutch pack applies progressive 0 to 100% locking between the front and rear output shafts. For example, if the rear axle starts rotating at a significantly higher rate than the front axle, the gerotor pump causes the clutch pack to progressively lock, transferring torque to the front axle until both axles are driven at the same speed. The ...
Jeep CJ; Jeep Wagoneer/Grand Wagoneer; Kaiser Jeep was purchased by AMC in 1970. The Buick 350 cu in (5.7 L) V8, AMC 232 I6, and AMC 327, 360 V8 engines in the FSJ Wagoneer and trucks used a 'nailhead' pattern TH400—also known as a "unipattern," as it was used by many other manufacturers (including Rolls-Royce and Jaguar) with an adapter ring—from 1965 to 1972.
AMC 20s have an 8 7/8" ring gear and use a 29 spline axle shaft. The AMC 20 was most often used with V8 engines in cars and Jeeps . It was also used in the AM General Humvee .
Ads
related to: jeep xj rear axle identification code chartquadratec.com has been visited by 10K+ users in the past month