enow.com Web Search

  1. Ads

    related to: rj45 connector through hole plug bracket

Search results

  1. Results from the WOW.Com Content Network
  2. Registered jack - Wikipedia

    en.wikipedia.org/wiki/Registered_jack

    The connector commonly used for twisted-pair Ethernet is a non-keyed 8P8C connector, quite distinct from that used for RJ45S. The new ARJ45 interface, however, is a plug and jack allowing higher transmission rates, and the jack can, optionally, be backward-compatible with the common 8P8C plugs of Gigabit Ethernet and earlier standards.

  3. Telephone jack and plug - Wikipedia

    en.wikipedia.org/wiki/Telephone_jack_and_plug

    For example, telephone cables in the UK typically have a BS 6312 (UK standard) plug at the wall end and a 6P4C or 6P2C modular connector at the telephone end: this latter may be wired as per the RJ11 standard (with pins 3 and 4), or it may be wired with pins 2 and 5, as a straight-through cable from the BT plug (which uses pins 2 and 5 for the ...

  4. GG45 - Wikipedia

    en.wikipedia.org/wiki/GG45

    GG45 is a variant of ARJ45 that allows for cables terminated with male 8P8C (AKA RJ45) connectors to be plugged into GG45 jacks. However, GG45 cables cannot plug into 8P8C jacks as a protrusion on the socket is designed to activate a switch on the jack for the alternative contact positions.

  5. Keystone module - Wikipedia

    en.wikipedia.org/wiki/Keystone_module

    Some keystones use a pass-through type connector, where there is a jack on both the front face and the rear side. Others only have a jack on the front and employ a different mechanism for hard-wiring signal cables to the rear, such as a mini 110 block , an insulation-displacement connector , or a crimp or solder connection.

  6. ANSI/TIA-568 - Wikipedia

    en.wikipedia.org/wiki/ANSI/TIA-568

    A cable terminated according to T568A on one end and T568B on the other is a crossover cable when used with the earlier twisted-pair Ethernet standards that use only two of the pairs because the pairs used happen to be pairs 2 and 3, the same pairs on which T568A and T568B differ. Crossover cables are occasionally needed for 10BASE-T and ...

  7. Modular connector - Wikipedia

    en.wikipedia.org/wiki/Modular_connector

    The first types of small modular telephone connectors were created by AT&T in the mid-1960s for the plug-in handset and line cords of the Trimline telephone. [1] Driven by demand for multiple sets in residences with various lengths of cords, the Bell System introduced customer-connectable part kits and telephones, sold through PhoneCenter stores in the early 1970s. [2]

  1. Ads

    related to: rj45 connector through hole plug bracket