Search results
Results from the WOW.Com Content Network
DIN 5483-3: DIN 5480-1: Involute splines based on reference diameters – Part 1: Generalities: Active: DIN 5480-2: Involute splines based on reference diameters – Part 2: Nominal and inspection dimensions: Active: DIN 5480-15: Involute splines based on reference diameters – Part 15: Inspection: Active: DIN 5483-1
A spline is a ridge or tooth [1] [2] [3] on a drive shaft that matches with a groove in a mating piece and transfers torque to it, maintaining the angular correspondence between them. For instance, a gear mounted on a shaft might use a male spline on the shaft that matches the female spline on the gear.
Shaft angle. A shaft angle is the angle between the axes of two non-parallel gear shafts. In a pair of crossed helical gears, the shaft angle lies between the oppositely rotating portions of two shafts. This applies also in the case of worm gearing. In bevel gears, the shaft angle is the sum of the two
ISO 500-2 Narrow-track tractors, dimensions for master shield and clearance zone; ISO 500-3 Main PTO dimensions and spline dimensions, location of PTO. The original type (designated as Type 1) calls for operation at 540 revolutions per minute (rpm). A shaft that rotates at 540 rpm has six splines on it, and a diameter of 1 + 3 ⁄ 8 inches (35 ...
Axle shaft diameter 1.41” Front (32 spline) 1.46” Rear (32 spline) 1.50” Front (35 spline) 1.50” Rear (35 spline) Inner axle shaft splines: 16, 23, 30, 32, 33 or 35 Aftermarket inner axle shaft splines: 40 for after market, high performance axles, equivalent to Dana 70 components; Pinion shaft diameter: 1.625" Pinion shaft splines: 10 or 29
35 Spline axle shafts with a 1.5 in (38 mm) diameter; Ratios 3.08 to 4.30. Current production ratios offered are 3.31, 3.55, 3.73, and 4.30. Since ca. 2005, the gears are formed by the face hob process, formerly face milled process.
Hirth joint made from anodized aluminum to show the meshing of the teeth Hirth joint (disassembled) between the semi-axles of a Campagnolo Ultra-Torque crankset. Face spline joints consist of a ring of radial splines or teeth milled or ground into the end faces of two rotary components such as a drive shaft and the hub of a wheel.
The following stresses are induced in the shafts. Shear stresses due to the transmission of torque (due to torsional load). Bending stresses (tensile or compressive) due to the forces acting upon the machine elements like gears and pulleys as well as the self weight of the shaft. Stresses due to combined torsional and bending loads.