Search results
Results from the WOW.Com Content Network
They appear in the Butler–Volmer equation and related expressions. The symmetry factor and the charge transfer coefficient are dimensionless. [1] According to an IUPAC definition, [2] for a reaction with a single rate-determining step, the charge transfer coefficient for a cathodic reaction (the cathodic transfer coefficient, α c) is defined as:
This is the energy (i.e. work) per charge which is required to move a (very small) positive charge at constant velocity across the cell membrane from the exterior to the interior. (If the charge is allowed to change velocity, the change of kinetic energy and production of radiation [ 1 ] must be taken into account.)
The limiting current in electrochemistry is the limiting value of a faradaic current that is approached as the rate of charge transfer to an electrode is increased. The limiting current can be approached, for example, by increasing the electric potential or decreasing the rate of mass transfer to the electrode. It is independent of the applied ...
Electrochemical kinetics is the field of electrochemistry that studies the rate of electrochemical processes. This includes the study of how process conditions, such as concentration and electric potential, influence the rate of oxidation and reduction reactions that occur at the surface of an electrode, as well as an investigation into electrochemical reaction mechanisms.
The adenylate energy charge is an index used to measure the energy status of biological cells.. ATP or Mg-ATP is the principal molecule for storing and transferring energy in the cell : it is used for biosynthetic pathways, maintenance of transmembrane gradients, movement, cell division, etc...
Intuitively one may understand these limits as follows: if an ion is only found outside a cell, then the flux is Ohmic (proportional to voltage) when the voltage causes the ion to flow into the cell, but no voltage could cause the ion to flow out of the cell, since there are no ions inside the cell in the first place.
Since the valence has already been accounted for above, the charge q A of each ion in the equation above, therefore, should be interpreted as +1 or -1 depending on the polarity of the ion. There is such a current associated with every type of ion that can cross the membrane; this is because each type of ion would require a distinct membrane ...
Ions also carry an electric charge that forms an electric potential across a membrane. If there is an unequal distribution of charges across the membrane, then the difference in electric potential generates a force that drives ion diffusion until the charges are balanced on both sides of the membrane.