Search results
Results from the WOW.Com Content Network
log 10 of anydrous ammonia vapor pressure. Uses formula shown below. ... Heat capacity, c p, of anhydrous ammonia gas. Uses polynomial obtained from CHERIC. [8]
One GGE of natural gas is 126.67 cubic feet (3.587 m 3) at standard conditions. This volume of natural gas has the same energy content as one US gallon of gasoline (based on lower heating values: 900 BTU/cu ft (9.3 kWh/m 3) of natural gas and 114,000 BTU/US gal (8.8 kWh/L) for gasoline). [22]
The rate constant, k, of this reaction depends on the temperature of the environment, with a value of at 10 K. [179] The rate constant was calculated from the formula = (/) . For the primary formation reaction, a = 1.05 × 10 −6 and B = −0.47 .
The contribution of the muscle to the specific heat of the body is approximately 47%, and the contribution of the fat and skin is approximately 24%. The specific heat of tissues range from ~0.7 kJ · kg−1 · °C−1 for tooth (enamel) to 4.2 kJ · kg−1 · °C−1 for eye (sclera). [13]
The U.S. Energy Information Administration defines the barrel of oil equivalent as about 6 gigajoules (1.7 megawatt-hours; 5.7 million British thermal units). [1] The value is necessarily approximate as various grades of oil and gas have slightly different heating values.
Ammonia solutions decrease in density as the concentration of dissolved ammonia increases. At 15.6 °C (60.1 °F), the density of a saturated solution is 0.88 g/ml; it contains 35.6% ammonia by mass, 308 grams of ammonia per litre of solution, and has a molarity of approximately 18 mol/L.
Only certain lighter than air gases are suitable as lifting gases. Dry air has a density of about 1.29 g/L (gram per liter) at standard conditions for temperature and pressure (STP) and an average molecular mass of 28.97 g/mol, [1] and so lighter-than-air gases have a density lower than this.
Graham found experimentally that the rate of effusion of a gas is inversely proportional to the square root of the molar mass of its particles. [1] This formula is stated as: =, where: Rate 1 is the rate of effusion for the first gas. (volume or number of moles per unit time). Rate 2 is the rate of effusion for the second gas. M 1 is the molar ...