enow.com Web Search

  1. Ads

    related to: sprinkler gpm chart

Search results

  1. Results from the WOW.Com Content Network
  2. K-factor (fire protection) - Wikipedia

    en.wikipedia.org/wiki/K-factor_(fire_protection)

    K-Factors have also previously been calculated and published using the United States customary units of pound per square inch (psi) and gallon per minute (gpm). Within the United States, US measurements are still often used instead of metric.

  3. Fire sprinkler system - Wikipedia

    en.wikipedia.org/wiki/Fire_sprinkler_system

    Another example would be a manufacturing facility classified as ordinary hazard group 2 where a typical design area would be 1,500 square feet (140 m 2) and the design density would be 0.2 US gallons per minute (0.76 L/min) per 1 square foot (0.093 m 2) or a minimum of 300 US gallons per minute (1,100 L/min) applied over the 1,500-square-foot ...

  4. Matched precipitation rate - Wikipedia

    en.wikipedia.org/wiki/Matched_precipitation_rate

    In order to be "matched" all sprinkler heads in a given zone must have the same rate of precipitation. This can be achieved by matching the gallonage of a standard rotor to its arc and reducing range accordingly (i.e. 2 gallons at 90 degrees, 4 gallons at 180 degrees, or 8 gallons if the head does a full circle) or by using MPR nozzles or ...

  5. Water flow test - Wikipedia

    en.wikipedia.org/wiki/Water_flow_test

    A water flow test, also known as a hydrant flow test, [1] is a way to measure the water supply available at a building site, usually for the purposes of installing a water based fire protection system (fire sprinkler system).

  6. Hazen–Williams equation - Wikipedia

    en.wikipedia.org/wiki/Hazen–Williams_equation

    Q = flow, gpm (gallons per minute) C = pipe roughness coefficient; d = inside pipe diameter, in (inches) Note: Caution with U S Customary Units is advised. The equation for head loss in pipes, also referred to as slope, S, expressed in "feet per foot of length" vs. in 'psi per foot of length' as described above, with the inside pipe diameter, d ...

  7. Hydraulic calculation - Wikipedia

    en.wikipedia.org/wiki/Hydraulic_calculation

    The hydraulic calculation procedure is defined in the applicable reference model codes such as that published by the US-based National Fire Protection Association (NFPA), [2] or the EN 12845 standard, Fixed firefighting system – Automatic sprinkler systems – Design, installation and maintenance. [3]

  1. Ads

    related to: sprinkler gpm chart