enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Toothed belt - Wikipedia

   en.wikipedia.org/wiki/Toothed_belt

   A gilmer belt was a brand or trade name for a mechanical belt used for transferring power between axles in a machine.The gilmer belt was originally sold by the L. H. Gilmer company after 1949, [9] and represents one of the earliest toothed belt designs.

3. Mechanical advantage device - Wikipedia

   en.wikipedia.org/wiki/Mechanical_advantage_device

   Examples of rope and pulley systems illustrating mechanical advantage. Consider lifting a weight with rope and pulleys. A rope looped through a pulley attached to a fixed spot, e.g. a barn roof rafter, and attached to the weight is called a single pulley. It has a mechanical advantage (MA) = 1 (assuming frictionless bearings in the pulley ...

4. Belt (mechanical) - Wikipedia

   en.wikipedia.org/wiki/Belt_(mechanical)

   Belt replacement is an obvious solution, and eventually the mandatory one (because no belt lasts forever). Often, though, before the replacement option is executed, retensioning (via pulley centerline adjustment) or dressing (with any of various coatings) may be successful to extend the belt's lifespan and postpone replacement.

5. Pulley - Wikipedia

   en.wikipedia.org/wiki/Pulley

   A pulley is a wheel on an axle or shaft enabling a taut cable or belt passing over the wheel to move and change direction, or transfer power between itself and a shaft. A sheave or pulley wheel is a pulley using an axle supported by a frame or shell ( block ) to guide a cable or exert force.

6. Differential pulley - Wikipedia

   en.wikipedia.org/wiki/Differential_pulley

   A dumb pulley can lift very large masses a short distance. It consists of two fixed pulleys of unequal radii that are attached to each other and rotate together, a single pulley bearing the load, and an endless rope looped around the pulleys. To avoid slippage, the rope is usually replaced by a chain, and the connected pulleys by sprockets.

7. Shaft (mechanical engineering) - Wikipedia

   en.wikipedia.org/wiki/Shaft_(mechanical_engineering)

   The following stresses are induced in the shafts.. Shear stresses due to the transmission of torque (due to torsional load).; Bending stresses (tensile or compressive) due to the forces acting upon the machine elements like gears and pulleys as well as the self weight of the shaft.