Search results
Results from the WOW.Com Content Network
spin or spinout where a vehicle rotates in one direction during the skid. understeer and oversteer where front or rear wheels lose traction during cornering, causing a vehicle to follow a larger or smaller turning radius. burnout where a vehicle slips or spins its tires during acceleration.
Classic bootleg turns can be performed only on cars with a manual transmission and are most easily accomplished with a rear-wheel-drive car, as the spinning back wheels aid in the turn. This is because the maneuver is essentially a controlled fishtail-like spin-out. Vehicles with an automatic transmission can be modified to make a bootleg turn ...
The terms "opposite lock" and "counter-steering" refer to the position of the steering wheel during the maneuver, which is turned in the opposite direction to that of the bend. The technique works best on loose or wet surfaces where the friction between the tires and the road is not too high, but can also be used on asphalt or other surfaces ...
Lift-off oversteer (also known as trailing-throttle oversteer, throttle off oversteer, or lift-throttle oversteer) is a form of sudden oversteer.While cornering, a driver who closes the throttle (by lifting a foot off the accelerator, hence the name), usually at a high speed, can cause such sudden deceleration that the vertical load on the tires shifts from rear to front, in a process called ...
The back end will swing out and the vehicle will turn toward the inside of the curve. If the steering angle is not changed, then the front wheels will trace out a smaller and smaller circle while the rear wheels continue to swing around the front of the car. This is what is happening when a car 'spins out'.
Performing this maneuver entails rotating the rear or front of the vehicle around the opposite set of wheels in a continuous motion, creating (ideally) a circular skid-mark pattern of rubber on a carriageway and possibly even causing the tires to emit smoke from friction. [1]
During fishtailing, [2] the rear end of the car skids to one side, which must be offset by the driver counter-steering, which is turning the front wheels in the same direction as the skid, (e.g. left if the rear swings left) [1] and reducing engine power. Over-correction will result in a skid in the opposite direction; hence the name.
Power oversteer is the process of applying power through the throttle pedal while turning to break the traction forces on the driving wheels. Doing this causes the vehicle to slide, and is also known as a powerslide, and the vehicles movement is primarily based on the non-driving wheels (usually the steering wheels).