Search results
Results from the WOW.Com Content Network
Speaker wire is a passive electrical component described by its electrical impedance, Z.The impedance can be broken up into three properties which determine its performance: the real part of the impedance, or the resistance, and the imaginary component of the impedance: capacitance or inductance.
Sixteen ohm drivers (or loudspeakers systems) would be connected to the 16-ohm tap, 8 ohm to the 8 ohm tap, etc. This is significant since the ratio between the loudspeaker impedance and the amplifier's impedance at a particular frequency provides damping (i.e., energy absorption) for the back EMF generated by a driver.
Line out provides an audio signal output and line in receives a signal input. The line in/out connections on consumer-oriented audio equipment are typically unbalanced, with a 3.5 mm (0.14 inch, but commonly called "eighth inch") 3-conductor TRS minijack connector providing ground, left channel, and right channel, or stereo RCA jacks.
A loudspeaker (commonly referred to as a speaker or, more fully, a speaker system) is a combination of one or more speaker drivers, an enclosure, and electrical connections (possibly including a crossover network). The speaker driver is an electroacoustic transducer [1]: 597 that converts an electrical audio signal into a corresponding sound. [2]
Two front speakers; one on the left of the screen and one on the right of the screen, One front speaker cable just above or below the screen which is the middle front; Two rear speakers; one on the left and one of the right in line with front left and right speaker locations
Bottom: bi-wiring. Loudspeaker bi-wired using banana plugs. Bi-wiring is a means of connecting a loudspeaker to an audio amplifier, primarily used in hi-fi systems. Normally, there is one pair of connectors on a loudspeaker and a single cable (two conductors) runs from the amplifier output to the terminals at the loudspeaker housing.
An automotive wiring diagram, showing useful information such as crimp connection locations and wire colors. These details may not be so easily found on a more schematic drawing. A wiring diagram is a simplified conventional pictorial representation of an electrical circuit. It shows the components of the circuit as simplified shapes, and the ...
The name IMF was adopted because Bud Fried had demonstrated the first prototype speakers at the New York hi fi show, and because of the publicity and the fact that he had used his name on the then unnamed speakers, we stuck with the name which was a mistake on our part. It was never his company. After our lawsuit he called his speakers Fried. [7]