enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Fixture unit - Wikipedia

   en.wikipedia.org/wiki/Fixture_unit

   A Fixture Unit is not a flow rate unit but a design factor. A fixture unit is equal to 1 cubic foot (0.028 m 3) of water drained in a 1 + 1 ⁄ 4 inches (32 mm) diameter pipe over one minute. [2] One cubic foot of water is roughly 7.48 US gallons (28.3 L; 6.23 imp gal). A Fixture Unit is used in plumbing design for both water supply and waste ...

3. Hazen–Williams equation - Wikipedia

   en.wikipedia.org/wiki/Hazen–Williams_equation

   The equation for head loss in pipes, also referred to as slope, S, expressed in "feet per foot of length" vs. in 'psi per foot of length' as described above, with the inside pipe diameter, d, being entered in feet vs. inches, and the flow rate, Q, being entered in cubic feet per second, cfs, vs. gallons per minute, gpm, appears very similar.

4. Pipe support - Wikipedia

   en.wikipedia.org/wiki/Pipe_support

   A pipe support or pipe hanger is a designed element that transfer the load from a pipe to the supporting structures. The load includes the weight of the pipe proper, the content that the pipe carries, all the pipe fittings attached to pipe, and the pipe covering such as insulation. The four main functions of a pipe support are to anchor, guide ...

5. Low-flow fixtures - Wikipedia

   en.wikipedia.org/wiki/Low-flow_fixtures

   The energy policy EPAct 1992 for residential buildings, restricted toilets to a maximum of 1.6 gpf (Gallons per flush). Kitchen and bathroom faucets were limited to a flow rate of 2.2 gpm (gallons per minute) at 60 psi, and residential shower heads were limited to a flowrate of 2.5 gpm at 80 psi.

6. Water flow test - Wikipedia

   en.wikipedia.org/wiki/Water_flow_test

   where: [2] Q f = total residual flow during the test (gallons per minute); c = discharge coefficient (unitless). This is usually 1.0 if using a diffuser. If using a wand to measure the stagnation pressure, the coefficient value depends on the shape of the flow hydrant orifice.

7. Miner's inch - Wikipedia

   en.wikipedia.org/wiki/Miner's_inch

   The miner's inch is a method of measuring the amount of flow a particular water supply system (such as a flume or sluice) is capable of supplying. The miner ’s inch measures the amount of water that would flow through a slot of a given area at a given pressure (for example, at a head of 6 inches of water , or 1.5 kPa .)