Search results
Results from the WOW.Com Content Network
IPv6 hosts are required to support multiple addresses per interface; moreover, every IPv6 host is required to configure a link-local address even when global addresses are available. IPv6 hosts may additionally self-configure additional addresses on receipt of router advertisement messages, thus eliminating the need for a DHCP server.
Link-local addresses may be assigned manually by an administrator or by automatic operating system procedures. In Internet Protocol (IP) networks, they are assigned most often using stateless address autoconfiguration, a process that often uses a stochastic process to select the value of link-local addresses, assigning a pseudo-random address that is different for each session.
IPv6-to-IPv6 Network Prefix Translation (NPTv6) is a specification for IPv6 to achieve address-independence at the network edge, similar to network address translation (NAT) in Internet Protocol version 4 (IPv4).
IPv6 hosts may automatically generate IP addresses internally using stateless address autoconfiguration (SLAAC), or they may be assigned configuration data with DHCPv6, or both. IPv6 hosts that use stateless autoconfiguration may need information other than what SLAAC provides on a given network.
A unique local address (ULA) is an Internet Protocol version 6 (IPv6) address in the address range fc00:: / 7. [1] These addresses are non-globally reachable [ 2 ] (routable only within the scope of private networks, but not the global IPv6 Internet).
In IPv6 global addresses are used end-to-end, so even home networks may need to distribute public, routable IP addresses to hosts. Since it would not be practical to manually provision networks at scale, in IPv6 networking, DHCPv6 prefix delegation ( RFC 3633 ; RFC 8415 § 6.3) is used to assign a network address prefix and automate ...
The payload of an IPv6 packet is typically a datagram or segment of the higher-level transport layer protocol, but may be data for an internet layer (e.g., ICMPv6) or link layer (e.g., OSPF) instead. IPv6 packets are typically transmitted over the link layer (i.e., over Ethernet or Wi-Fi), which encapsulates each packet in a frame.
The native IPv6 host then responds as usual to the client's Teredo IPv6 address, which eventually causes the packet to find a Teredo relay, which initiates a connection to the client (possibly using the Teredo server for NAT piercing). The Teredo Client and native IPv6 host then use the relay for communication as long as they need to.