Search results
Results from the WOW.Com Content Network
This page lists examples of the orders of magnitude of molar concentration. Source values are parenthesized where unit conversions were performed. M denotes the non-SI unit molar: 1 M = 1 mol/L = 10 −3 mol/m 3.
In the International System of Units (SI), the coherent unit for molar concentration is mol/m 3. However, most chemical literature traditionally uses mol/dm 3, which is the same as mol/L. This traditional unit is often called a molar and denoted by the letter M, for example: 1 mol/m 3 = 10 −3 mol/dm 3 = 10 −3 mol/L = 10 −3 M = 1 mM = 1 ...
Thermodynamic data is usually presented as a table or chart of function values for one mole of a substance (or in the case of the steam tables, one kg). A thermodynamic datafile is a set of equation parameters from which the numerical data values can be calculated. Tables and datafiles are usually presented at a standard pressure of 1 bar or 1 ...
For example, the conversion of a flowrate of kg/s to kmol/s only requires dividing by the molar mass in g/mol (as = =) without multiplying by 1000 unless the basic SI unit of mol/s were to be used, which would otherwise require the molar mass to be converted to kg/mol.
If specific heat is expressed per mole of atoms for these substances, none of the constant-volume values exceed, to any large extent, the theoretical Dulong–Petit limit of 25 J⋅mol −1 ⋅K −1 = 3 R per mole of atoms (see the last column of this table). For example, Paraffin has very large molecules and thus a high heat capacity per mole ...
The molar ratio allows for conversion between moles of one substance and moles of another. For example, in the reaction 2 CH 3 OH + 3 O 2 → 2 CO 2 + 4 H 2 O. the amount of water that will be produced by the combustion of 0.27 moles of CH 3 OH is obtained using the molar ratio between CH 3 OH and H 2 O of 2 to 4.
The ideal gas equation can be rearranged to give an expression for the molar volume of an ideal gas: = = Hence, for a given temperature and pressure, the molar volume is the same for all ideal gases and is based on the gas constant: R = 8.314 462 618 153 24 m 3 ⋅Pa⋅K −1 ⋅mol −1, or about 8.205 736 608 095 96 × 10 −5 m 3 ⋅atm⋅K ...
When expressed in percent, it is known as the mole percent or molar percentage (unit symbol %, sometimes "mol%", equivalent to cmol/mol for 10 −2). The mole fraction is called amount fraction by the International Union of Pure and Applied Chemistry (IUPAC) [ 1 ] and amount-of-substance fraction by the U.S. National Institute of Standards and ...