Ad
related to: gasoline engine throttle position sensor diagram
Search results
Results from the WOW.Com Content Network
A throttle position sensor (TPS) is a sensor used to monitor the throttle body valve position for the ECU of an engine. The sensor is usually located on the butterfly spindle/shaft, so that it can directly monitor the position of the throttle. More advanced forms of the sensor are also used. For example, an extra "closed throttle position ...
A typical ETC system consists of three major components: (i) an accelerator pedal module (ideally with two or more independent sensors), (ii) a throttle valve that can be opened and closed by an electric motor (sometimes referred to as an electric or electronic throttle body (ETB)), and (iii) a powertrain or engine control module (PCM or ECM). [4]
The ECU then increases the amount of fuel injected by the injectors in order to obtain the required air-fuel ratio. Often a throttle position sensor (TPS) is connected to the shaft of the throttle plate to provide the ECU with information on whether the throttle is in the idle position, wide-open throttle (WOT) position, or somewhere in between ...
The Ford EEC (Electronic Engine Control) system, which utilized the Toshiba TLCS-12 microprocessor, went into mass production in 1975. [ 7 ] The first Bosch engine management system was the Motronic 1.0 , which was introduced in the 1979 BMW 7 Series (E23) [ 8 ] This system was based on the existing Bosch Jetronic fuel injection system, to ...
Alternatively, a manifold vacuum sensor can be used. The manifold vacuum sensor signal, the throttle position, and the crankshaft speed can then be used by the engine control unit to calculate the correct amount of fuel. In modern engines, a combination of all these systems is used. [5]
Therefore, an accelerator pump is often used to briefly provide extra fuel as the throttle is opened. [12] When the driver presses the throttle pedal, a small piston or diaphragm pump injects extra fuel directly into the carburetor throat. [13] The accelerator pump can also be used to "prime" an engine with extra fuel prior to attempting a cold ...
In the US, this kind of single-point injection was marketed as 'throttle body injection' (TBI, by GM), or 'central fuel injection' (CFI, by Ford). Mono-Jetronic is different from all other known single-point systems, in that it only relies on a throttle position sensor for judging the engine load.
A fuel-injected engine may alternatively use a mass airflow sensor (MAF sensor) to detect the intake airflow. A typical naturally aspirated engine configuration employs one or the other, whereas forced induction engines typically use both; a MAF sensor on the Cold Air Intake leading to the turbo and a MAP sensor on the intake tract post- turbo ...
Ad
related to: gasoline engine throttle position sensor diagram