Search results
Results from the WOW.Com Content Network
Ethernet packet. The SFD (start frame delimiter) marks the end of the packet preamble. It is immediately followed by the Ethernet frame, which starts with the destination MAC address. [1] In computer networking, an Ethernet frame is a data link layer protocol data unit and uses the underlying Ethernet physical layer transport
A frame is a series of bits generally composed of frame synchronization bits, the packet payload, and a frame check sequence. Examples are Ethernet frames, Point-to-Point Protocol (PPP) frames, Fibre Channel frames, and V.42 modem frames. Often, frames of several different sizes are nested inside each other.
The original 2.94 Mbit/s Ethernet implementation had eight-bit addresses and other differences in frame format. [10] 10BASE5: 802.3-1985 (8) AUI, N, vampire tap: 500 m RG-8X Original standard uses a single coaxial cable in which a connection is made by tapping into the single cable, drilling in to make contact with the core and the screen.
End nodes utilizing a MAC layer will usually detect an oversized Ethernet frame and cease receiving. A bridge/switch will not forward the frame. [64] A non-uniform frame size configuration in the network using jumbo frames may be detected as jabber by end nodes. [citation needed] Jumbo frames are not part of the official IEEE 802.3 Ethernet ...
IEEE 802.1Q, often referred to as Dot1q, is the networking standard that supports virtual local area networking (VLANs) on an IEEE 802.3 Ethernet network. The standard defines a system of VLAN tagging for Ethernet frames and the accompanying procedures to be used by bridges and switches in handling such frames.
IEEE 802.3 is a working group and a collection of standards defining the physical layer and data link layer's media access control (MAC) of wired Ethernet.The standards are produced by the working group of Institute of Electrical and Electronics Engineers (IEEE).
Depending on whether the diagram is intended for formal or informal use, certain details may be lacking and must be determined from context. For example, the sample diagram does not indicate the physical type of connection between the PCs and the switch, but since a modern LAN is depicted, Ethernet may be assumed.
By far the most popular FCS algorithm is a cyclic redundancy check (CRC), used in Ethernet and other IEEE 802 protocols with 32 bits, in X.25 with 16 or 32 bits, in HDLC with 16 or 32 bits, in Frame Relay with 16 bits, [3] in Point-to-Point Protocol (PPP) with 16 or 32 bits, and in other data link layer protocols.