enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Nominal Pipe Size - Wikipedia

   en.wikipedia.org/wiki/Nominal_Pipe_Size

   Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...

3. National pipe thread - Wikipedia

   en.wikipedia.org/wiki/National_pipe_thread

   The standard for Nominal Pipe Size (often abbreviated NPS, which should not be confused with the abbreviation NPS for the straight thread form standard) is loosely related to the inside diameter of Schedule 40 series of sizes. Because of the pipe wall thickness of Schedule pipe, the actual diameter of the NPT threads is larger than the Nominal ...

4. Iron pipe size - Wikipedia

   en.wikipedia.org/wiki/Iron_pipe_size

   STD is identical to Schedule 40 for NPS 1/8 to NPS 10, inclusive, and indicates .375" wall thickness for NPS 12 and larger. XS is identical to SCH 80 for NPS 1/8 to NPS 8, inclusive, and indicates .500" wall thickness for NPS 8 and larger. Different definitions exist for XXS, but it is generally thicker than schedule 160. [2]

5. Ductile iron pipe - Wikipedia

   en.wikipedia.org/wiki/Ductile_iron_pipe

   Pipe dimensions are standardised ... 40 56 (2.205) 4.8 (0.189) 6.0 (0.236) ... Australia adopted at an early point the imperial British cast iron pipe standard BS 78 ...

6. British Standard Pipe - Wikipedia

   en.wikipedia.org/wiki/British_Standard_Pipe

   These standard pipe threads are formally referred to by the following sequence of blocks: the words, Pipe thread, the document number of the standard (e.g., ISO 7 or EN 10226) the symbol for the pipe thread type: G, external and internal parallel (ISO 228) R, external taper (ISO 7) Rp, internal parallel (ISO 7/1) Rc, internal taper (ISO 7)

7. ASTM A53 steel - Wikipedia

   en.wikipedia.org/wiki/ASTM_A53_steel

   Scope of ASTM A53 Standard ASTM A53 is standard specification for pipe, steel, black and hot dipped, zinc-coated, welded and seamless. This specification covers seamless and welded black and hot-dipped galvanized steel pipe in NPS 1⁄8 to NPS 26 [DN 6 to DN 650] (Note 1), inclusive, with nominal wall thickness (Note 2) as given in Table X2.2 ...

8. Pipe (fluid conveyance) - Wikipedia

   en.wikipedia.org/wiki/Pipe_(fluid_conveyance)

   The number system, like Sch 40, 80, 160, were set long ago and seem a little odd. For example, Sch 20 pipe is even thinner than Sch 40, but same OD. And while these pipes are based on old steel pipe sizes, there is other pipe, like cpvc for heated water, that uses pipe sizes, inside and out, based on old copper pipe size standards instead of steel.

9. United States customary units - Wikipedia

   en.wikipedia.org/wiki/United_States_customary_units

   Nominal Pipe Size is used for the outside diameter of pipes. Below NPS14, the NPS number is not consistent with the pipe diameter in inches. Copper tubing, however, is measured in nominal size, 1 ⁄ 8 inch less than the outside diameter. The Schedule system is used for standard pipe thicknesses.