enow.com Web Search

  1. Ads

    related to: plastic 90 degree angle trim

Search results

  1. Results from the WOW.Com Content Network
  2. Crown molding - Wikipedia

    en.wikipedia.org/wiki/Crown_molding

    Crown treatments made out of wood may be a single piece of trim, or a build-up of multiple components to create a more elaborate look. The main element, or the only in a plain installation, is a piece of trim that is sculpted on one side and flat on the other, with standard angles forming 90-degrees milled on both its top and bottom edges.

  3. Square (tool) - Wikipedia

    en.wikipedia.org/wiki/Square_(tool)

    A set square is used in technical drawing, providing a straightedge at a right angle or another particular planar angle to a baseline. They are commonly made from clear plastic. The most common set squares are 45° squares, (one 90° corner and two 45° corners) and 60/30 triangles (a 90°, a 60° and a 30° corner).

  4. Set square - Wikipedia

    en.wikipedia.org/wiki/Set_square

    These set squares come in two usual forms, both right triangles: one with 90-45-45 degree angles, the other with 30-60-90 degree angles. Combining the two forms by placing the hypotenuses together will also yield 15° and 75° angles. They are often purchased in packs with protractors and compasses.

  5. Design of plastic components - Wikipedia

    en.wikipedia.org/wiki/Design_of_plastic_components

    In most instances, 1degree per side will be sufficient, but between 2 degree and 5 degree per side would be preferable. If the design is not compatible with 1 degree, then allow for 0.5 degree on each side. Even a small draft angle, such as 0.25 degree, is preferable to none at all. [3]

  6. Street elbow - Wikipedia

    en.wikipedia.org/wiki/Street_elbow

    Street elbows are available with bend angles of 90°, 45°, and 22.5°. They can be used in many plumbing applications, including water supply, drainage, sewers, vents, central vacuum systems, compressed air and gas lines, heating and air conditioning, sump pump drains, and other locations where plumbing fittings would be used to join sections of pipe.

  7. Miter joint - Wikipedia

    en.wikipedia.org/wiki/Miter_joint

    90º miter joint (pieces ready to be joined) Miter joint of two pipes A miter joint (mitre in British English) is a joint made by cutting each of two parts to be joined, across the main surface, usually at a 45° angle, to form a corner, usually to form a 90° angle, though it can comprise any angle greater than 0 degrees.

  1. Ads

    related to: plastic 90 degree angle trim