Search results
Results from the WOW.Com Content Network
Furthermore, modern devices often use a feedback mechanism to monitor and adjust the sound pressure level in the cavity so that it is constant regardless of the cavity / microphone size. Sound calibrators normally generate a 1 kHz sine tone; 1 kHz is chosen since the A-weighted SPL is equal to the linear level at 1 kHz. Sound calibrators should ...
The best type of microphone for sound level meters is the condenser microphone, which combines precision with stability and reliability. [1] The diaphragm of the microphone responds to changes in air pressure caused by sound waves. That is why the instrument is sometimes referred to as a sound pressure level meter (SPL).
The internal electronic circuitry of an active noise-canceling mic attempts to subtract noise signal from the primary microphone. The circuit may employ passive or active noise canceling techniques to filter out the noise, producing an output signal that has a lower noise floor and a higher signal-to-noise ratio .
Court reporter tests his stenomask. [1]A stenomask is a hand-held microphone built into a padded, soundproof enclosure that fits over the speaker's mouth or nose and mouth. . Some lightweight versions may be fitted with an elastic neck strap to hold them in place while freeing the user's hands for other tas
The predecessor of the directional boundary microphone was a directional microphone placed in an Electrovoice Mic Mouse, a foam block that suspended a conventional microphone horizontally just above a surface. Because conventional microphone diaphragms are relatively large (> 1 cm diameter), phase interference from surface sound reflections ...
The rest of the article is a list of formulas like "period = 1 / frequency" and "frequency = 1 / period" which are the same formula restated and can be found in the reciprocal article, talk about some SI units (Hertz and seconds), and another list of formulas like "wavelength / time = velocity" that are restated 6 times. Seems like a pointless ...
The carbon microphone, by virtue of using a power supply, gives a power gain. This can readily be demonstrated by connecting a battery, microphone and earphone in series. If the microphone and earphone are brought in contact the system will oscillate. This is only possible if the power gain around the loop is greater than unity.
At a distance of about 50 cm (0.5 m) the time delay for a signal reaching first one and then the other microphone from the side is approximately 1.5 ms (1 to 2 ms). If the distance is increased between the microphones it effectively decreases the pickup angle.