Search results
Results from the WOW.Com Content Network
In order to make a slipped knot (also slipped loop and quick release knot), a bight must be passed, rather than the end. This slipped form of the knot is more easily untied. The traditional bow knot used for tying shoelaces is simply a reef knot with the final overhand knot made with two bights instead of the ends.
The overhand loop is a simple knot which forms a fixed loop in a rope. Made by tying an overhand knot in the bight, it can be tied anywhere along a rope (does not need any working end). The knot can be used for attaching clips, hooks, other rope, etc., but has the disadvantage that it is likely to jam tight when the rope has been pulled and the ...
A bight is a slack part in the middle of a rope, usually a curve or loop. [1] [2] Knots that can be tied without access to either end of the rope are called knots in the bight. To tie a knot with a bight is to double up the rope into a bight and then tie the knot using the double rope.
Tying an overhand knot. There are a number of ways to tie the Overhand knot. Thumb method – create a loop and push the working end through the loop with your thumb. Overhand method – create a bight, by twisting the hand over at the wrist and sticking your hand in the hole, pinch the working end with your fingers and pull through the loop.
To release the knot, pry apart the two hitches with a bending motion. However, it can often be difficult to untie. To help avoid this problem, tie a slipped variation: in the second half-hitch, pass through a bight, as when tying your shoe, rather than the entire free end.
Figure-eight knot a.k.a. savoy knot, Flemish knot – type of knot created by a loop on the bight; Figure-eight loop – type of knot created by a loop on the bight; Figure-of-nine loop – forms a fixed loop in a rope; Fireman's chair knot – knot tied in the bight forming two adjustable, lockable loops
The knot is tied in the same way the original bowline is, except with a doubled rope (using a bight). An overhand loop is formed in the rope, the working end is passed back through that loop, behind the standing part of the rope, back through the loop and pulled tight.
A slipped half hitch [1] [2] is a knot in which the weight of the load the rope carries depresses the loop sufficiently to keep it in place until the load item is placed in its location. When no longer required the free end may be pulled and draw the loop through and so release the load.