Search results
Results from the WOW.Com Content Network
The solenoid/diaphragm timer uses more battery power throughout the "on" cycle because the solenoid must be actuated the entire time that the water flow is "on". The ball valve timer using the motor and gear actuator only uses more battery power during the few seconds that motor is used to turn the water flow on or off.
A sprinkler system timer is an electrical device that is used to set an irrigation sprinkler system to come on automatically at a certain time. Irrigation timers first appeared in the early 1960s to control large-radius lawn sprinklers, which at the time usually contained their own electrically operated valve (most golf-course sprinklers still use this type of actuation).
Most automatic irrigation valves are diaphragm valves in which the water above the diaphragm must be discharged for the valve to open. In a hydraulic system, the controller and valves are connected via small plastic tubes approximately 4 mm (¼ in) in diameter. The controller opens the tube connected to the valve, allowing that valve to open.
For example, an irrigation sprinkler system, programmed to turn on at set times could be an example of an open-loop system if it does not measure soil moisture as a form of feedback. Even if rain is pouring down on the lawn, the sprinkler system would activate on schedule, wasting water. Another example is a stepper motor used for control of ...
The first automatic timer, the dashpot timer has been used in many different machines and has many variations. Pneumatic, hydraulic-action, and mercury displacement timers. Being used in a variety of things such as printing presses , motors , and even irrigation systems , the dashpot timer has seen many applications.
Rain sensors for irrigation systems are available in both wireless and hard-wired versions, most employing hygroscopic disks that swell in the presence of rain and shrink back down again as they dry out — an electrical switch is in turn depressed or released by the hygroscopic disk stack, and the rate of drying is typically adjusted by controlling the ventilation reaching the stack.
AOL latest headlines, entertainment, sports, articles for business, health and world news.
McGall was an employee of the Burgess Battery Company at the time. In 1937 W.B. Schulte, [2] McGall's employer, started the company MICRO SWITCH. The company and the Micro Switch trademark have been owned by Honeywell Sensing and Control since 1950. [3] The name has become a generic trademark for any snap-action switch. Companies other than ...