Search results
Results from the WOW.Com Content Network
Category 2 seal are intended for API-610 This category is applicable for temperatures between –40 °F and 750 °F (-40 °C and 400 °C) and pressures to 615 PSI (42 bar). Category 3 seals are essentially the original seals of 1st Edition and are also intended for API-610 pumps. Category 3 seals are intended for the most demanding applications.
Depending on the seal type these two angles are varied to create a pressure distribution at the seal contact line which has a steeper slope on the oil side of the seal. The shallower the slope on the oil side of the seal, the wetter the seal will run. The spring is positioned such that axially the centerline of the spring is biased to the air ...
ISO 17712:2103 Freight containers — Mechanical seals - updated the 2010 version: offers "a single source of information on mechanical seals which are acceptable for securing freight containers in international commerce". [5] Supported by C-TPAT (the use of "H" class seals is required). [6] ISO 17713 Meteorology – Wind measurements
Typical O-ring and application. An O-ring, also known as a packing or a toric joint, is a mechanical gasket in the shape of a torus; it is a loop of elastomer with a round cross-section, designed to be seated in a groove and compressed during assembly between two or more parts, forming a seal at the interface.
Labyrinth seals are also found on pistons, which use them to store oil and seal against high pressure during compression and power strokes, as well as on non-rotating shafts. In these applications, it is the long and difficult path and the formation of controlled fluid vortices plus some limited contact-sealing action that creates the seal.
In mechanical engineering, an end-face mechanical seal (often shortened to mechanical seal) is a type of seal used in rotating equipment, such as pumps, mixers, blowers, and compressors. When a pump operates, the liquid could leak out of the pump between the rotating shaft and the stationary pump casing. Since the shaft rotates, preventing this ...
A static hydraulic seal is located in a groove and sees no movement - only sealing within its confined space, acting like a gasket. To achieve this the gasket should be under pressure. The pressure is applied by tightening of the bolts. Examples of static seals include O-rings, flange seals, and cover seals. Dynamic
This is an incomplete list of DIN standards.. The "STATUS" column gives the latest known status of the standard.. If a standard has been withdrawn and no replacement specification is listed, either the specification was withdrawn without replacement or a replacement specification could not be identified.