Search results
Results from the WOW.Com Content Network
When considering an antenna's directional pattern, gain with respect to a dipole does not imply a comparison of that antenna's gain in each direction to a dipole's gain in that direction. Rather, it is a comparison between the antenna's gain in each direction to the peak gain of the dipole (1.64). In any direction, therefore, such numbers are 2 ...
An antenna designer must take into account the application for the antenna when determining the gain. High-gain antennas have the advantage of longer range and better signal quality, but must be aimed carefully in a particular direction. Low-gain antennas have shorter range, but the orientation of the antenna is inconsequential.
Antenna gain (G) is defined as antenna efficiency (e) multiplied by antenna directivity (D) which is expressed mathematically as: =. A useful relationship between omnidirectional radiation pattern directivity (D) in decibels and half-power beamwidth (HPBW) based on the assumption of a sin ( b θ ) / b θ {\displaystyle \sin(b\theta )/{b ...
A high-gain antenna (HGA) is a directional antenna with a focused, narrow beam width, permitting more precise targeting of the radio signals. [1] Most commonly referred to during space missions , [ 2 ] these antennas are also in use all over Earth , most successfully in flat, open areas where there are no mountains to disrupt radiowaves.
Here, the gain and effective area of antenna 2 are fixed, because the orientation of this antenna is fixed with respect to the first. Now for a given disposition of the antennas, the reciprocity theorem requires that the power transfer is equally effective in each direction, i.e.
An antenna's directivity is greater than its gain by an efficiency factor, radiation efficiency. [1] Directivity is an important measure because many antennas and optical systems are designed to radiate electromagnetic waves in a single direction or over a narrow-angle.
For the Arecibo antenna at 2.4 GHz, the beamwidth was 0.028°. Since parabolic antennas can produce very narrow beams, aiming them can be a problem. Some parabolic dishes are equipped with a boresight so they can be aimed accurately at the other antenna. There is an inverse relation between gain and beam width.
The half-power point is the angle off boresight at which the antenna gain first falls to half power (approximately −3 dB) [a] from the peak. The angle between the −3 dB points is known as the half-power beam width (or simply beam width). [4] Beamwidth is usually but not always expressed in degrees and for the horizontal plane.