Search results
Results from the WOW.Com Content Network
An antenna designer must take into account the application for the antenna when determining the gain. High-gain antennas have the advantage of longer range and better signal quality, but must be aimed carefully in a particular direction. Low-gain antennas have shorter range, but the orientation of the antenna is inconsequential.
When considering an antenna's directional pattern, gain with respect to a dipole does not imply a comparison of that antenna's gain in each direction to a dipole's gain in that direction. Rather, it is a comparison between the antenna's gain in each direction to the peak gain of the dipole (1.64). In any direction, therefore, such numbers are 2 ...
Omnidirectional radiation patterns are produced by the simplest practical antennas, monopole and dipole antennas, consisting of one or two straight rod conductors on a common axis. Antenna gain (G) is defined as antenna efficiency (e) multiplied by antenna directivity (D) which is expressed mathematically as: =.
A high-gain antenna (HGA) is a directional antenna with a focused, narrow beam width, permitting more precise targeting of the radio signals. [1] Most commonly referred to during space missions , [ 2 ] these antennas are also in use all over Earth , most successfully in flat, open areas where there are no mountains to disrupt radiowaves.
For the Arecibo antenna at 2.4 GHz, the beamwidth was 0.028°. Since parabolic antennas can produce very narrow beams, aiming them can be a problem. Some parabolic dishes are equipped with a boresight so they can be aimed accurately at the other antenna. There is an inverse relation between gain and beam width.
The half-power point is the angle off boresight at which the antenna gain first falls to half power (approximately −3 dB) [a] from the peak. The angle between the −3 dB points is known as the half-power beam width (or simply beam width). [4] Beamwidth is usually but not always expressed in degrees and for the horizontal plane.
A directive antenna with moderate gain of about 8 dBi often used at UHF frequencies. Consists of a dipole mounted in front of two reflective metal screens joined at an angle, usually 90°. Used as a rooftop UHF television antenna and for point-to-point data links. Parabolic The most widely used high gain antenna at microwave frequencies and above.
Note that for a given antenna feedpoint impedance, an antenna's gain or increases according to the square of , so that the effective length for an antenna relative to different wave directions follows the square root of the gain in those directions. But since changing the physical size of an antenna inevitably changes the impedance (often by a ...