Search results
Results from the WOW.Com Content Network
At a distance of about 50 cm (0.5 m) the time delay for a signal reaching first one and then the other microphone from the side is approximately 1.5 ms (1 to 2 ms). If the distance is increased between the microphones it effectively decreases the pickup angle.
With this technique is the angle between the microphone axes α = ± 55° = 110° and the distance between the cardioid microphones (microphone basis) is in this case a = 17 cm and gives a total recording angle of 96°. The choice between one and the other depends on the recording angle of the microphone system and not on the distance to and ...
The predecessor of the directional boundary microphone was a directional microphone placed in an Electrovoice Mic Mouse, a foam block that suspended a conventional microphone horizontally just above a surface. Because conventional microphone diaphragms are relatively large (> 1 cm diameter), phase interference from surface sound reflections ...
The condenser microphone, invented at Western Electric in 1916 by E. C. Wente, [22] is also called a capacitor microphone or electrostatic microphone—capacitors were historically called condensers. The diaphragm acts as one plate of a capacitor, and audio vibrations produce changes in the distance between the plates.
The internal electronic circuitry of an active noise-canceling mic attempts to subtract noise signal from the primary microphone. The circuit may employ passive or active noise canceling techniques to filter out the noise, producing an output signal that has a lower noise floor and a higher signal-to-noise ratio .
Proximity effect can be viewed in two ways. In some settings, sound engineers may view it as undesirable, and so the type of microphone or microphone practice may be chosen in order to reduce the proximity effect. On the other hand, some microphone users seek to intentionally use the proximity effect, such as beat boxing singers in hip hop music.
Two pins are used for the mono headphone signal and two pins for the unbalanced microphone signal. The 4-pin XLR connector is also commonly used on amateur radio microphones, but transferring unbalanced audio instead, and using the 4th pin (with the common ground) for a push-to-talk (PTT) circuit activated by a button on the microphone.
Parabolic microphone used at an American college football game. A parabolic microphone is a microphone that uses a parabolic reflector to collect and focus sound waves onto a transducer, in much the same way that a parabolic antenna (e.g. satellite dish) does with radio waves. Though they lack high fidelity, parabolic microphones have great ...