Search results
Results from the WOW.Com Content Network
Ferrocement or ferro-cement [1] is a system of construction using reinforced mortar [2] or plaster (lime or cement, sand, and water) applied over an "armature" of metal mesh, woven, expanded metal, or metal-fibers, and closely spaced thin steel rods such as rebar. The metal commonly used is iron or some type of steel, and the mesh is made with ...
Unlike regular concrete, ECC has a tensile strain capacity in the range of 3–7%, [1] compared to 0.01% for ordinary portland cement (OPC) paste, mortar or concrete. ECC therefore acts more like a ductile metal material rather than a brittle glass material (as does OPC concrete), leading to a wide variety of applications.
Polymer concrete is a type of concrete that uses a polymer to replace lime-type cements as a binder. One specific type is epoxy granite , where the polymer used is exclusively epoxy . In some cases the polymer is used in addition to portland cement to form Polymer Cement Concrete (PCC) or Polymer Modified Concrete (PMC). [ 1 ]
In building construction, concrete uses cement as a binder. Asphalt pavement uses bitumen binder. Traditionally straw and natural fibres are used to strengthen clay in wattle-and-daub construction and in the building material cob which would otherwise become brittle after drying. Sand is added to improve compressive strength, hardness and ...
It is used as a binder of the sand when doing sand casting of all common metals. It allows for the rapid production of a strong mold or core by three main methods. [citation needed] Method 1 requires passing carbon dioxide gas through the mixture of sand and sodium silicate in the sand molding box or core box.
Their addition allows to decrease the water-to-cement ratio of concrete or mortar without negatively affecting the workability of the mixture. It enables the production of self-consolidating concrete and high-performance concrete. The water–cement ratio is the main factor determining the concrete strength and its durability. Superplasticizers ...
It was, in fact, nothing like material used by the Romans, but was a "natural cement" made by burning septaria – nodules that are found in certain clay deposits, and that contain both clay minerals and calcium carbonate. The burnt nodules were ground to a fine powder. This product, made into a mortar with sand, set in 5–15 minutes.
Bitumen mortar was also used at a lower-frequency, including in the Great Bath at Mohenjo-daro. [5] [6] In early Egyptian pyramids, which were constructed during the Old Kingdom (~2600–2500 BCE), the limestone blocks were bound by a mortar of mud and clay, or clay and sand. [7] In later Egyptian pyramids, the mortar was made of gypsum, or ...