Search results
Results from the WOW.Com Content Network
Static VLAN assignments are created by assigning ports to a VLAN. As a device enters the network, the device automatically assumes the VLAN of the port. If the user changes ports and needs access to the same VLAN, the network administrator must manually make a port-to-VLAN assignment for the new connection.
IEEE 802.1Q, often referred to as Dot1q, is the networking standard that supports virtual local area networking (VLANs) on an IEEE 802.3 Ethernet network. The standard defines a system of VLAN tagging for Ethernet frames and the accompanying procedures to be used by bridges and switches in handling such frames.
Devices on separate VLANs or in a typical local area network are unable to communicate with each other. Therefore, it is often used to forward traffic between locally attached hosts on separate logical routing domains or to facilitate routing table administration, distribution and relay.
VLAN Trunking Protocol (VTP) is a Cisco proprietary protocol that propagates the definition of Virtual Local Area Networks on the whole local area network. [1] To do this, VTP carries VLAN information to all the switches in a VTP domain. VTP advertisements can be sent over 802.1Q, and ISL trunks.
Private VLAN, also known as port isolation, is a technique in computer networking where a VLAN contains switch ports that are restricted such that they can only communicate with a given uplink. The restricted ports are called private ports. Each private VLAN typically contains many private ports, and a single uplink.
One issue that may arise is that some network devices cannot handle high rates of broadcast, unknown-unicast or multicast traffic. In such cases, it is possible to limit the BUM traffic for specific ports in order to have a control on the number of packets or bytes that are flooded on the VLAN to other devices.
This is known as inter-VLAN routing. On layer-3 switches it is accomplished by the creation of layer-3 interfaces (SVIs). Inter VLAN routing, in other words routing between VLANs, can be achieved using SVIs. [1] SVI or VLAN interface, is a virtual routed interface that connects a VLAN on the device to the Layer 3 router engine on the same device.
IEEE 802.3 is a working group and a collection of standards defining the physical layer and data link layer's media access control (MAC) of wired Ethernet.The standards are produced by the working group of the Institute of Electrical and Electronics Engineers (IEEE).