Search results
Results from the WOW.Com Content Network
Barcol hardness is measured on a scale from 0 to 100 with the typical range being between 50B and 90B. A measurement of 60B is roughly equivalent to a Shore hardness of 80D or a Rockwell hardness M100. [4] [6] As defined in ASTM D 2583 the scale divisions from 0-100 should each indicate a depth of 0.0076 mm or the equivalent 0.0003 inches. [7]
Epoxy value derives from the Epoxy equivalent weight (EEW) or Weight Per Epoxide (WPE) and is a measure of the epoxy content of an epoxy resin or epoxy reactive diluent, or glycidyl ether. [1] This is an important parameter as it allows determination of the correct mix ratio of an epoxy system with a curing agent. [ 2 ]
Applications for superaustenitic stainless steel alloy AL-6XN include chemical processing, oil and gas, medical – sterilization and power generation [3] with specific applications identified in desalination, water piping systems. transformer cases in marine environments, food processing equipment, FGD scrubbers, reverse osmosis, and heat exchangers.
This is roughly equivalent to the obsolete NIJ Level II ballistic protection level. [10] NIJ HG2 9mm Luger.44 Magnum: This armor would protect against: 124 grain 9mm Luger Full Metal Jacketed Round Nose (FMJ RN) at a velocity of 1470 ft/s (448 m/s) 240 grain .44 Magnum Jacketed Hollow Point (JHP) at a velocity of 1430 ft/s (436 m/s).
In the 1930s, national studies demonstrated the Deval test did not correlate with the service record of sampled rock altogether, while an LA loss rating of less than 40% was a reliable indicator of quality. [9] The federal standard for LA abrasion testing was formally adopted by the ASTM in 1937. [10]
The longer it takes, the higher the viscosity and thus the higher the SAE code. Larger numbers are thicker. J300 specifies a viscosity range for each non-winter grade, with higher grade numbers corresponding to higher viscosities. In addition, a minimum viscosity measured at a high temperature and high-shear rate (HTHS, ASTM D4683) is also ...
The Janka hardness test results tabulated below followed ASTM D 1037-12 testing methods. Lumber stocks tested range from 1" to 2" (25–50 mm) thick. The tabulated Janka hardness numbers are an average. There is a standard deviation associated with each species, but these values are not given. [citation needed] No testing was done on actual ...
The salt spray test (or salt fog test) is a standardized and popular corrosion test method, used to check corrosion resistance of materials and surface coatings.Usually, the materials to be tested are metallic (although stone, ceramics, and polymers may also be tested) and finished with a surface coating which is intended to provide a degree of corrosion protection to the underlying metal.