enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. R-value (insulation) - Wikipedia

   en.wikipedia.org/wiki/R-value_(insulation)

   Installed faced fiberglass batt insulation with its R-value visible (R-21) [1]. The R-value (in K⋅m 2 /W) is a measure of how well a two-dimensional barrier, such as a layer of insulation, a window or a complete wall or ceiling, resists the conductive [2] flow of heat, in the context of construction. [3]

3. Insulated siding - Wikipedia

   en.wikipedia.org/wiki/Insulated_siding

   Producers report an average R-value of 2.0 - 5.5, significantly more than that of other siding products including fiber cement, brick and stucco. Homeowners also report insulated siding serves as a noise barrier to external sound. Insulated vinyl siding with added fan fold foam board insulation raises the R-value to 3.5 - 7.5.

4. Rigid panel - Wikipedia

   en.wikipedia.org/wiki/Rigid_panel

   A multi-family residential building under construction with rigid panel exterior insulating sheathing. Rigid panel insulation, also referred to as continuous insulation, [1] can be made from foam plastics such as polyurethane (PUR), polyisocyanurate (PIR), and polystyrene, or from fibrous materials such as fiberglass, rock and slag wool.

5. Structural insulated panel - Wikipedia

   en.wikipedia.org/wiki/Structural_insulated_panel

   EPS is the most common of the foams used and has an R-value (thermal resistance) of about 4 °F·ft 2 ·h/Btu (equivalent to about 0.7 K·m 2 /W) per 25 mm thickness, which would give the 3.5 inches (89 mm) of foam in a 4.5-inch-thick (110 mm) panel an R value of 13.8 (caution: extrapolating R-values over thickness may be imprecise due to non ...

6. Building insulation material - Wikipedia

   en.wikipedia.org/wiki/Building_insulation_material

   Closed-cell foams are superior insulators. While open-cell foams typically have R-values of 3 to 4 per inch (RSI-0.53 to RSI-0.70 per inch), closed-cell foams can attain R-values of 5 to 8 per inch (RSI-0.88 to RSI-1.41 per inch). This is important if space is limited, because it allows a thinner layer of insulation to be used.

7. Building insulation - Wikipedia

   en.wikipedia.org/wiki/Building_insulation

   For example, in the US the insulation standard for attics, is recommended to be at least R-38 US units, (equivalent to R-6.7 or a U value of 0.15 in SI units). [5] The equivalent standard in the UK are technically comparable, the approved document L would normally require an average U value over the roof area of 0.11 to 0.18 depending on the ...