Search results
Results from the WOW.Com Content Network
The contacts in each row of these connectors are spaced 326/3000 of an inch apart, or approximately 0.1087 inches (2.76 mm), and the rows are spaced 0.112 inches (2.84 mm) apart; the pins in the two rows are offset by half the distance between adjacent contacts in a row. [7]
You are free: to share – to copy, distribute and transmit the work; to remix – to adapt the work; Under the following conditions: attribution – You must give appropriate credit, provide a link to the license, and indicate if changes were made.
A diagram of the DB-25 connector. Date: 18 June 2006 (original upload date) ... Dimensions User Comment; current: 07:08, 23 June 2006: 558 × 150 (8 KB) Mobius ...
A DB-25 connector as described in the RS-232 standard Data circuit-terminating equipment (DCE) and data terminal equipment (DTE) network. In telecommunications, RS-232 or Recommended Standard 232 [1] is a standard originally introduced in 1960 [2] for serial communication transmission of data.
Ribbon cable with three connectors. Ribbon cables are usually specified by two numbers: the spacing or pitch of the conductors, and the number of conductors or ways. A spacing of 0.05 inch (1.27 mm) is the most usual, allowing for a two-row connector with a pin spacing of 0.1 inch (2.54 mm).
These connector's contacts are densely packed with 0.64 mm (0.025 inch) spacing between contact centers in the same row. These connectors are intended for interconnections on printed wiring board (PWB), PWB-to-cable, cable-to-panel, or cable-to-cable on miniaturized equipment sub-assemblies with low power requirements. The connectors are ...
Mini-Centronics 36-pin male connector (top) with Micro ribbon 36-pin male Centronics connector (bottom) The Apple II Parallel Printer Port connected to the printer via a folded ribbon cable; one end connected to the connector at the top of the card, and the other end had a 36-pin Centronics connector.
In some instances USB through version 2 on motherboards – 2.54 mm pitch, 10 pins, 2×5 (2 rows of 5 pins) [9] For all of the above connectors, the computer manufacturer typically attaches a female IDC connector onto one end of a ribbon cable, and later slides that connector onto a matching male box header or pin header on the computer ...