enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   Inch-sized wood screws in the U.S. are defined by ANSI-B18.6.1-1981(R2003), while in Germany they are defined by DIN 95 (Slotted raised countersunk (oval) head wood screws), DIN 96 (Slotted round head wood screws), and DIN 97 (Slotted countersunk (flat) head wood screws). Security head screw: These screws are used for security purposes and ...

3. Self-tapping screw - Wikipedia

   en.wikipedia.org/wiki/Self-tapping_screw

   The countersunk head has a Pozidriv recess. A self-tapping screw is a screw that can tap its own hole as it is driven into the material. More narrowly, self-tapping is used only to describe a specific type of thread-cutting screw intended to produce a thread in relatively soft material or sheet materials, excluding wood screws.

4. Furniture screw - Wikipedia

   en.wikipedia.org/wiki/Furniture_screw

   Wood screws are a common type of screw in furniture. A furniture screw can refer to any type of screw (and sometimes nut) used on furniture. Different types of screws have different uses in furniture. [1] According to a 1986 article in New York Times, screws on old furniture can be difficult to remove due to rust. [2]

5. Pocket-hole joinery - Wikipedia

   en.wikipedia.org/wiki/Pocket-hole_joinery

   Pocket screws are generally more expensive, but they are needed for a tight, strong joint. Pocket screws have a wide washer head to spread the load for a firm bond, and prevent screwing too far into the joint and cracking the wood. The self tapping screws will grip any type of wood, but coarse threads are needed for softer wood and fine threads ...

6. Set screw - Wikipedia

   en.wikipedia.org/wiki/Set_screw

   A set screw is often headless and threaded along its entire length, so that it will sit entirely inside that hole; in which case it may be called a grub screw or blind screw. Once fully and firmly screwed into the first object, the projecting tip of the set screw presses hard against the second object, acting like a clamp .

7. List of screw drives - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_drives

   Instead of covering up the screw head that it serves as an aesthetic part of the design. Ten different recess sizes are available for the Mortorq. The smallest of these, the PMT-000 can be used with screws that have a head diameter as small as 2.5 mm. While the largest called PMT-7 can be used on screws with a head diameter of 35 mm. [35]