Search results
Results from the WOW.Com Content Network
A brace on a square-rigged ship is a rope (line) used to rotate a yard around the mast, to allow the ship to sail at different angles to the wind. Braces are always used in pairs, one at each end of a yard ( yardarm ), [ 1 ] termed port brace and starboard brace of a given yard or sail (e.g., the starboard main-brace is the brace fixed to the ...
The afterguy, working guy, or simply guy and sometimes known as a brace is attached to the windward clew of the spinnaker, and runs through the jaws on the outboard end of the pole and back to the cockpit. The afterguy is used to rotate the outboard end of the pole around the mast in order to optimize the sail's effectiveness, depending on the ...
1. To make a sail fill with wind on the opposite side normally used for sailing forward. A fore and aft headsail is backed by either not moving the sail across when tacking, or by hauling it to windward with the weather sheet. A square sail is backed by hauling the yards round with the braces. The sail is then aback. [3] 2.
%PDF-1.5 %âãÏÓ 191 0 obj > endobj xref 191 25 0000000016 00000 n 0000001437 00000 n 0000001560 00000 n 0000001882 00000 n 0000002862 00000 n 0000003042 00000 n 0000003184 00000 n 0000003359 00000 n 0000003594 00000 n 0000004073 00000 n 0000004242 00000 n 0000081823 00000 n 0000082060 00000 n 0000082215 00000 n 0000107550 00000 n 0000107790 00000 n 0000108080 00000 n 0000142116 00000 n ...
Either of the braces attached to the yard of the mainsail (the largest and lowest sail on the mainmast) on a square-rigged vessel. mainmast. Also simply main. 1. The tallest mast on a ship [1] with more than one mast, especially the tallest mast on a full-rigged ship. 2. On a ship with more than one mast, the second mast from the bow. mainmast head
Braces are the lines that control the angle of the yards. On square-rigged ships, the mainbrace was the longest line in all of the running rigging . [ 1 ] It was common to aim for the ship's rigging during naval battles.
Brails, in a sailing ship, are small lines used to haul in or up the edges or corners of sails, before furling. [1] On a ship rig, these brails are most often found on the mizzen sail. To haul and furl the sails, the command used in the early 18th century was hale up the brails or brail up the sails .
The spanker is the fore-and-aft sail at the lower right. On a square rigged ship, the spanker is a gaff-rigged fore-and-aft sail set from, and aft of, the aftmost mast. [1] [2] [3] Spankers are also called driver, jigger, and pusher sail. [4] On a schooner of four or more masts, the spanker is the sail on the mast nearest the stern. [5]