Search results
Results from the WOW.Com Content Network
Border Gateway Protocol (BGP) is a standardized exterior gateway protocol designed to exchange routing and reachability information among autonomous systems (AS) on the Internet. [2] BGP is classified as a path-vector routing protocol, [3] and it makes routing decisions based on paths, network policies, or rule-sets configured by a network ...
Multiprotocol Extensions for BGP (MBGP or MP-BGP), sometimes referred to as Multiprotocol BGP or Multicast BGP and defined in IETF RFC 4760, [1] is an extension to Border Gateway Protocol (BGP) that allows different types of addresses (known as address families) to be distributed in parallel.
Border Gateway Protocol (BGP) is an example of a path vector protocol. In BGP, the autonomous system boundary routers (ASBR) send path-vector messages to advertise the reachability of networks. Each router that receives a path vector message must verify the advertised path according to its policy.
BGP is the standard routing protocol used to exchange information about IP routing between autonomous systems. Each AS uses BGP to advertise prefixes that it can deliver traffic to. For example, if the network prefix 192.0.2.0 / 24 is inside AS 64496, then that AS will advertise to its provider(s) and/or peer(s) that it can deliver any traffic ...
This is a list of the IP protocol numbers found in the field Protocol of the IPv4 header and the Next Header field of the IPv6 header.It is an identifier for the encapsulated protocol and determines the layout of the data that immediately follows the header.
BGP is used by internet service providers (ISPs) and telecommunication companies. [ 4 ] Among the distance-vector protocols that have been described as a hybrid, because it uses routing methods associated with link-state routing protocols , is the proprietary Enhanced Interior Gateway Routing Protocol (EIGRP).
Normally the Border Gateway Protocol (BGP) used by the provider's routers only looks at the four-octet IP address, but the BGP Multiprotocol Extensions allow BGP to view the entire 12-octet VPN-IPv4 address, and carry routes from multiple "address families". If the route distinguisher Administrator subfield and the Assigned Number subfield of a ...
The outer label is used for normal MPLS forwarding in the service provider's network. If BGP is used to establish the VPLS, the inner label is allocated by a PE as part of a label block. If LDP is used, the inner label is a virtual circuit ID assigned by LDP when it first established a mesh between the participating PEs.