enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Air gap (plumbing) - Wikipedia

   en.wikipedia.org/wiki/Air_gap_(plumbing)

   In the base cabinet under the sink, the drain hose from the dishwasher feeds the "top" of the air gap, and the "bottom" of the air gap is plumbed into the sink drain below the basket, or into a garbage disposal unit. When installed and maintained properly, the air gap works as described above, and prevents drain water from the sink from backing ...

3. Drain-waste-vent system - Wikipedia

   en.wikipedia.org/wiki/Drain-waste-vent_system

   A sewer pipe is normally at neutral air pressure compared to the surrounding atmosphere.When a column of waste water flows through a pipe, it compresses air ahead of it in the system, creating a positive pressure that must be released so it does not push back on the waste stream and downstream traps, slow drainage, and induce potential clogs.

4. Pipe-in-pipe system - Wikipedia

   en.wikipedia.org/wiki/Pipe-in-pipe_system

   A water distribution cabinet with a pipe-in-pipe system. Internal pipes can be seen entering the external pipes in the bottom of the cabinet. In case of an internal leak, water will overflow through the external piping and can be detected inside the cabinet.

5. Husband says he's 'fixing the leaking sink,' but wife catches ...

   www.aol.com/finance/husband-says-fixing-leaking...

   Need help? Call us! 800-290-4726 Login / Join. Mail

6. Plumbing fixture - Wikipedia

   en.wikipedia.org/wiki/Plumbing_fixture

   The visible water surface in a toilet is the top of the trap's water seal. Each fixture drain, with exceptions, must be vented so that negative air pressure in the drain cannot siphon the trap dry, to prevent positive air pressure in the sewer from forcing gases past the water seal, and to prevent explosive sewer gas buildup.

7. Sink - Wikipedia

   en.wikipedia.org/wiki/Sink

   A bottom mount sink at the Ernest Hemingway House. Bottom-mount or under-mount sinks are installed below the countertop surface. The edge of the countertop material is exposed at the hole created for the sink (and so must be a carefully finished edge rather than a rough cut). The sink is then clamped to the bottom of the material from below.

8. AOL Mail

   mail.aol.com

   Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!

9. Tap (valve) - Wikipedia

   en.wikipedia.org/wiki/Tap_(valve)

   Tap tails are normally 1 ⁄ 2 " or 12 mm in diameter for sinks and 3 ⁄ 4 " or 19 mm for baths, although continental Europe sometimes uses a 3 ⁄ 8 " (still imperial) size. The same connection method is used for a ballcock. The term tap is widely used to describe the valve used to dispense draft beer from a keg, whether gravity feed or ...