Search results
Results from the WOW.Com Content Network
A control system includes control surfaces which, when deflected, generate a moment (or couple from ailerons) about the cg which rotates the aircraft in pitch, roll, and yaw. For example, a pitching moment comes from a force applied at a distance forward or aft of the cg, causing the aircraft to pitch up or down.
Ascending on a decompression buoy while slightly negatively buoyant makes accurate depth and ascent rate control relatively simple, by maintaining light tension on the line as it is reeled in, at the cost of carrying the equipment, a slightly longer time at depth during deployment, a few litres of gas for inflation, and the competence to deploy ...
The cockpit of a Slingsby T-67 Firefly two-seat light airplane.The flight instruments are visible on the left of the instrument panel. Flight instruments are the instruments in the cockpit of an aircraft that provide the pilot with data about the flight situation of that aircraft, such as altitude, airspeed, vertical speed, heading and much more other crucial information in flight.
The FAA publicly identified an “unsafe condition” that could result in a “loss of control” of certain Boeing 737 Max jets because of “nonconforming” installation of spoiler control wires.
In aeronautics, a descent is any time period during air travel where an aircraft decreases altitude, and is the opposite of an ascent or climb.. Descents are part of normal procedures, but also occur during emergencies, such as rapid or explosive decompression, forcing an emergency descent to below 3,000 m (10,000 ft) and preferably below 2,400 m (8,000 ft), respectively the maximum temporary ...
The transition level (TL) is the lowest flight level above the transition altitude. The table below shows the transition level according to transition altitude and QNH. When descending below the transition level, the pilot starts to refer to altitude of the aircraft by setting the altimeter to the QNH for the region or airfield.
This yields several momentary threshold values. In the following step, mean values are calculated for ascending and descending sequences separately. The mean value will be lower for descending sequences. In case of audiometry, the difference of the means in case of ascending vs. descending sequences has a diagnostic importance.
The portion of the semi-major axis extending from the primary at one focus to the periapsis is shown as a purple line in the diagram; the rest (from the primary/focus to the center of the orbit ellipse) is below the reference plane and not shown. Two elements define the orientation of the orbital plane in which the ellipse is embedded: