Ads
related to: axle puller slide hammerglobalindustrial.com has been visited by 100K+ users in the past month
jbtools.com has been visited by 10K+ users in the past month
Search results
Results from the WOW.Com Content Network
A slide hammer is a tool that attaches to an object needing to be pulled and transmits an impact force to the object without striking the object itself. Slide hammers typically consist of a long metal shaft with an attachment point at one end, a heavy weight that can slide along the shaft , and a stop for the weight to impact on the end ...
A typical spike puller is a small, two axle machine. Most spike pullers are designed only to remove spikes on one side of the tracks, meaning that two machines must be used together to remove all the spikes from both rails. Some larger spike pullers are designed to pull spikes on both rails at the same time, these are known as two rail or dual ...
The Adell and Starrett mechanism uses a sliding block crosswise through the hammer rather than an intermediate pin. The hammer has a hole through its center that the top of the punch sits in, and holds the top of the punch centered. The sliding block has a hole through it that, when reset, is misaligned with the hole through the hammer.
Constant lead barrel cam in an American Pacemaker lathe. This cam is used to provide a repeatable cross slide setting when threading with a single-point tool. A cylindrical cam, or barrel cam, is a cam in which the follower rides on the surface of a cylinder. In the most common type, the follower rides in a groove cut into the surface of a ...
A manual impact driver (for use with hammer) with screwdriver bits and adapters. An impact driver is a tool that delivers a strong, sudden rotational force and forward thrust. The force can be delivered either by striking with a hammer in the case of manual impact drivers, or mechanically in the case of powered impact drivers.
It consists of two, three, or four cams mounted on a common axle or two adjacent axles, so that pulling on the axle forces the cams to spread further apart. It is then attached to a sling and carabiner at the end of the stem. The SLCD is used by pulling on the "trigger" (a small handle) so that the cams retract together, then inserting it into ...
Ads
related to: axle puller slide hammerglobalindustrial.com has been visited by 100K+ users in the past month
jbtools.com has been visited by 10K+ users in the past month