Search results
Results from the WOW.Com Content Network
The main components of a parking pawl mechanism are the parking gear, parking pawl, actuator rod, cam collar, cam plate, pivot pin, and parking pawl return spring. The mechanism assembly is designed so that the parking pawl tooth collides and overrides the parking gear teeth (ratchets) until a safe engagement speed for the vehicle is reached.
A ratchet (occasionally spelled rachet) is a mechanical device that allows continuous linear or rotary motion in only one direction while preventing motion in the opposite direction. Ratchets are widely used in machinery and tools. The word ratchet is also used informally to refer to a ratcheting socket wrench.
A pawl is used in an anchor windlass to prevent a free-spooling chain by grabbing and snubbing an individual link. Similar mechanisms include a Devil's claw, or a claw and dog. Ratchet A pawl is used in combination with a ratchet gear in socket wrenches, bicycle freehubs, winches, ratchet reels for diving, fishing, and many other applications ...
Socket set with ratchet (above), four hex sockets and a universal joint. A socket wrench (or socket spanner) is a type of spanner (or wrench [1] in North American English) that uses a closed socket format, rather than a typical open wrench/spanner to turn a fastener, typically in the form of a nut or bolt.
The main components of a park by wire system include the driver interface which could be a lever, switch, or knob; an electronic control unit; and actuators which are capable of driving the parking pawl into and out of the locking position with the parking gear of the transmission. [2] [better source needed]
Freewheel mechanism Ratcheting freewheel mechanism (van Anden, 1869). In mechanical or automotive engineering, a freewheel or overrunning clutch is a device in a transmission that disengages the driveshaft from the driven shaft when the driven shaft rotates faster than the driveshaft.
Since the 1870s, in an improved version the pendulum drove a ratchet wheel via a pawl on the pendulum rod, and the ratchet wheel drove the rest of the clock train to indicate the time. The pendulum was not impelled on every swing or even at a set interval of time—it was only impelled when its arc of swing had decayed below a certain level.
This is a vertical spool with a ratchet mechanism similar to a conventional winch, but with no crank handle or other form of drive. [7] The line is wrapped around the spool and can be tightened or reeled in by pulling the tail line. The winch takes the load once the pull is stopped with little operator tension needed to hold it.