Ad
related to: ahci vs sata
Search results
Results from the WOW.Com Content Network
Some operating systems, notably Windows Vista, Windows 7, Windows 8, Windows 8.1 and Windows 10, do not configure themselves to load the AHCI driver upon boot if the SATA controller was not in AHCI mode at the time the operating system was installed. Although this is an easily rectifiable condition, it remains an ongoing issue with the AHCI ...
When enabled via the AHCI controller, this allows the SATA host bus adapter to enter a low-power state during periods of inactivity, thus saving energy. The drawback to this is increased periodic latency as the drive must be re-activated and brought back on-line before it can be used, and this will often appear as a delay to the end-user.
A 3.5-inch Serial ATA hard disk drive A 2.5-inch Serial ATA solid-state drive. SATA was announced in 2000 [4] [5] in order to provide several advantages over the earlier PATA interface such as reduced cable size and cost (seven conductors instead of 40 or 80), native hot swapping, faster data transfer through higher signaling rates, and more efficient transfer through an (optional) I/O queuing ...
Intel Rapid Storage Technology (RST) is a driver SATA AHCI and a firmware-based RAID solution built into a wide range of Intel chipsets. Currently also is installed as a driver for Intel Optane temporary storage units. It contains two operation modes that follow two Intel specific modes rather than the SATA standard. The name modes and the ...
Two Serial ATA (SATA) 3.0 controllers are integrated into the X99 chipset, providing a total of up to ten ports for storage devices and supporting speeds of up to 6 Gbit/s per port, with hardware support for the Advanced Host Controller Interface (AHCI) logical interface. Each SATA port may be enabled or disabled as needed.
The SAS is a new generation serial communication protocol for devices designed to allow for much higher speed data transfers and is compatible with SATA. SAS uses a mechanically identical data and power connector to standard 3.5-inch SATA1/SATA2 HDDs, and many server-oriented SAS RAID controllers are also capable of addressing SATA hard drives.
[4] [5] Linux kernels support AHCI natively since version 2.6.19, and FreeBSD fully supports AHCI since version 8.0. Windows Vista and Windows 7 also natively support AHCI, but their AHCI support (via the msahci service) must be manually enabled via registry editing if controller support was not present during their initial install.
Six SATA 3 Gbit/s ports in either legacy IDE or AHCI mode. Can support external eSATA; Intel High Definition Audio; Integrated gigabit LAN; AHCI support; Two EHCI host controllers (which support up to twelve USB 2.0 connections) with companion UHCI controllers to handle low-speed and full-speed USB devices; This part has the following variants:
Ad
related to: ahci vs sata