Search results
Results from the WOW.Com Content Network
An example of lateral earth pressure overturning a retaining wall. The lateral earth pressure is the pressure that soil exerts in the horizontal direction. It is important because it affects the consolidation behavior and strength of the soil and because it is considered in the design of geotechnical engineering structures such as retaining walls, basements, tunnels, deep foundations and ...
K a = Coefficient of active pressure w = weight density of soil h = depth of the section (below top soil) where the pressure is being evaluated. β = angle that the top surface of soil makes with the horizontal. φ = angle of internal friction of soil. The expression for passive pressure is: = where:
The angle of internal friction is thus closely related to the maximum stable slope angle, often called the angle of repose. But in addition to friction, soil derives significant shear resistance from interlocking of grains. If the grains are densely packed, the grains tend to spread apart from each other as they are subject to shear strain.
The average normal intergranular contact force per unit area is called the effective stress. If water is not allowed to flow in or out of the soil, the stress path is called an undrained stress path. During undrained shear, if the particles are surrounded by a nearly incompressible fluid such as water, then the density of the particles cannot ...
The amount of dilation depends strongly on the initial density of the soil. In general, the denser the soil, the greater the amount of volume expansion under shear. It has also been observed that the angle of internal friction decreases as the effective normal stress is decreased. [9]
Angle of internal friction for some materials Material Friction angle in degrees Rock: 30 ° Sand: 30 ° to 45 ° Gravel: 35 ° Silt: 26 ° to 35 ° Clay: 20 ° Loose sand 30 ° to 35 ° Medium sand 40 ° Dense sand 35 ° to 45 ° Sandy gravel > 34 ° to 48 °
The wedge is defined as the soil which extends beyond the failure plane of the soil type present at the wall site, and can be calculated once the soil friction angle is known. As the setback of the wall increases, the size of the sliding wedge is reduced. This reduction lowers the pressure on the retaining wall. [4]
Angle of repose of a heap of sand Sandpile from the Matemateca collection. The angle of repose, or critical angle of repose, [1] of a granular material is the steepest angle of descent or dip relative to the horizontal plane on which the material can be piled without slumping. At this angle, the material on the slope face is on the verge of ...