Search results
Results from the WOW.Com Content Network
Broadcast, unknown-unicast and multicast traffic (BUM traffic) [1] is network traffic transmitted using one of three methods of sending data link layer network traffic to a destination of which the sender does not know the network address. This is achieved by sending the network traffic to multiple destinations on an Ethernet network. [2]
The network with the longest subnet mask or network prefix that matches the destination IP address is the next-hop network gateway. The process repeats until a packet is delivered to the destination host, or earlier along the route, when a router has no default route available and cannot route the packet otherwise.
TCP/IP defines the addresses 192.168.4.0 (network ID address) and 192.168.4.255 (broadcast IP address). The office's hosts send packets to addresses within this range directly, by resolving the destination IP address into a MAC address with the Address Resolution Protocol (ARP) sequence and then encapsulates the IP packet into a MAC frame ...
NOTE: a RID is the highest logical (loopback) IP address configured on a router, if no logical/loopback IP address is set then the router uses the highest IP address configured on its active interfaces (e.g. 192.168.0.1 would be higher than 10.1.1.2). Usually the router with the second-highest priority number becomes the BDR.
Destination network unreachable 1: Destination host unreachable 2: Destination protocol unreachable 3: Destination port unreachable 4: Fragmentation required, and DF flag set 5: Source route failed 6: Destination network unknown 7: Destination host unknown 8: Source host isolated 9: Network administratively prohibited 10: Host administratively ...
In computer networking, a unicast flood occurs when a switch receives a unicast frame and the switch does not know that the addressee is on any particular switch port. Since the switch has no information regarding which port, if any, the addressee might be reached through, it forwards the frame through all ports aside from the one through which the frame was received.
When packets are sent over a network, the destination IP address is examined. If the destination IP is outside of the network, then the packet goes to the gateway for transmission outside of the network. The gateway is on the same network as end devices. The gateway address must have the same subnet mask as host devices. Each host on the ...
Used for loopback addresses to the local host [1] 169.254.0.0/16 169.254.0.0–169.254.255.255 65 536: Subnet Used for link-local addresses [5] between two hosts on a single link when no IP address is otherwise specified, such as would have normally been retrieved from a DHCP server 172.16.0.0/12 172.16.0.0–172.31.255.255 1 048 576: Private ...