Search results
Results from the WOW.Com Content Network
Code 1: A time critical event with response requiring lights and siren. This usually is a known and going fire or a rescue incident. Code 2: Unused within the Country Fire Authority. Code 3: Non-urgent event, such as a previously extinguished fire or community service cases (such as animal rescue or changing of smoke alarm batteries for the ...
When identifying the unit/firefighter alarm designation, the initial dispatch is referred to as a "first alarm" and is typically the largest. Subsequent alarms are calls for additional units, usually because the fire has grown and additional resources are needed to combat it, or because the incident is persisting long enough that firefighters on scene need to be relieved.
The NFPA 72 (National Fire Alarm and Signaling Code) is a standard published by the National Fire Protection Association every 3 years for installation of fire alarm systems and emergency communication systems in the United States.
Most fire alarm systems in Europe sound like a siren with alternating frequencies. Fire alarm electronic devices are known as horns in the United States and Canada and can be continuous or set to different codes. Fire alarm warning devices can also be set to different volume levels.
Alert or Alarm - Raise the alarm by triggering a fire alarm. Alert nearby persons to gain assistance in fighting the fire or alerting other people. Alert emergency services, site security and other emergency contacts as necessary. Confine or Contain - Contain the spread of the fire by closing nearby doors and windows if it is safe to do so. The ...
Fire: 10-70 Net message (State net traffic). Fire, phone alarm Fire alarm Fire 10-71 Proceed with traffic in sequence (busy here). Box alarm Advise nature of fire (size, type, and contents of building) — 10-72 — Second alarm Report progress on fire 10-73 Third alarm Smoke report 10-74 Fourth alarm Negative Negative 10-75 Fifth alarm In ...
Coded panels were the earliest type of central fire alarm control, and were made during the 1800s to the 1970s. A coded panel is similar in many ways to a modern conventional panel (described below), except each zone was connected to its own code wheel, which, depending on the way the panel was set up, would either do sets of four rounds of code until the initiating pull station was reset ...
Many modern fire alarm pull stations are single-action and only require the user to pull down a handle to sound the alarm. Other fire alarm pull stations are dual-action, and as such require the user to perform a second task before pulling down, such as lifting or pushing in a panel on the station or breaking a glass panel with an attached hammer.