Search results
Results from the WOW.Com Content Network
The strut will usually carry both the coil spring, on which the body is suspended, and the shock absorber, which is usually in the form of a cartridge mounted within the strut (see coilover). The strut can also have the steering arm built into the lower outer portion. The whole assembly is very simple and can be pre-assembled into a unit.
In 1947 Earle MacPherson patented the MacPherson strut for use on the Chevrolet Cadet. [4] [5] This was the first true strut suspension for cars: the stub axle was rigidly fixed to the strut, thus always keeping the same angle with it, rather than being attached through a swivelling joint as for Stout's Scarab.
As such, push-rod suspension systems allow for much greater high-speed stability, much lower levels of body-roll, and a much lower centre of gravity for the vehicle. [7] For pull-rod suspension systems, the only difference is the orientation of the rocker arms. In a push-rod system, the rocker arms are placed at the highest point in the assembly.
The Tilting Suspension System [27] (also known as the Leaning Suspension System) is not a different type or geometry of construction; moreover, it is a technology addition to the conventional suspension system. This kind of suspension system mainly consists of independent suspension (e.g., MacPherson strut, A-arm (double wishbone)). With the ...
Double wishbone suspension (front) on a Saab Quantum IV. The double-wishbone suspension can also be referred to as "double A-arms", though the arms themselves can be A-shaped or L-shaped. A single wishbone or A-arm can also be used in various other suspension types, such as variations of the MacPherson strut.
A rear viscous LSD is also used to improve high-speed stability and traction during low-speed cornering. Suspension. The B4 is suspended on the same platform as other Liberty models – MacPherson struts under the front and an all-new multi-link rear Chapman strut arrangement. The front suspension incorporates cast aluminium L-shaped transverse ...
The Legacy-derived platform was given the SI chassis (SIシャシー) [5] (SUBARU Intelligent-Chassis) designation in 2007; [6] the 'SI chassis' featured a fully-independent suspension, with front struts and rear double wishbones. [7] SGP retains the same basic front strut/rear wishbone suspension as 'SI chassis', with refinements to improve ...
A strut bar, strut brace, or strut tower brace (STB) is an automotive suspension accessory on a monocoque or unibody chassis to provide extra stiffness between the strut towers. With a MacPherson strut suspension system where the spring and shock absorber combine in one suspension unit, which also replaces the upper control arm, the entire ...