Search results
Results from the WOW.Com Content Network
Since the electric pump does not require mechanical power from the engine, it is feasible to locate the pump anywhere between the engine and the fuel tank. The reasons that the fuel pump is typically located in the fuel tank are: By submerging the pump in fuel at the bottom of the tank, the pump is cooled by the surrounding fuel; Liquid fuel by ...
Breaker arm with contact points at the left. The pivot is on the right and the cam follower is in the middle of the breaker arm. A contact breaker (or "points") is a type of electrical switch, found in the ignition systems of spark-ignition internal combustion engines. The switch is automatically operated by a cam driven by the engine.
It gives the contact stress as a function of the normal contact force, the radii of curvature of both bodies and the modulus of elasticity of both bodies. Hertzian contact stress forms the foundation for the equations for load bearing capabilities and fatigue life in bearings, gears, and any other bodies where two surfaces are in contact.
1952 Shell Oil film showing the development of the diesel engine from 1877. The diesel engine, named after the German engineer Rudolf Diesel, is an internal combustion engine in which ignition of diesel fuel is caused by the elevated temperature of the air in the cylinder due to mechanical compression; thus, the diesel engine is called a compression-ignition engine (CI engine).
Injection pump for a 12-cylinder diesel engine An injection pump is the device that pumps fuel into the cylinders of a diesel engine . Traditionally, the injection pump was driven indirectly from the crankshaft by gears, chains or a toothed belt (often the timing belt ) that also drives the camshaft .
Hot-bulb engine (two-stroke). 1. Hot bulb. 2. Cylinder. 3. Piston. 4. Crankcase Old Swedish hot-bulb engine in action. The hot-bulb engine, also known as a semi-diesel [1] or Akroyd engine, is a type of internal combustion engine in which fuel ignites by coming in contact with a red-hot metal surface inside a bulb, followed by the introduction of air (oxygen) compressed into the hot-bulb ...
The constant stroke pump element on the way up draws fuel from the supply duct in to the chamber, and as long as the electric solenoid valve remains de-energized the fuel line is open. Spill phase The pump element is on the way down, and as long as the solenoid valve remains de-energized the fuel line is open and fuel flows in into the return duct.
Cylinder liners (also known as sleeves) are thin metal cylinder-shaped parts which are inserted into the engine block to form the inner wall of the cylinder. [4] [5] Alternatively, an engine can be 'sleeveless', where the cylinder walls are formed by the engine block with a wear-resistant coating, such as Nikasil or plasma-sprayed bores.