enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Printed circuit board manufacturing - Wikipedia

   en.wikipedia.org/wiki/Printed_circuit_board...

   Printed circuit board manufacturing is the process of manufacturing bare printed circuit boards (PCBs) and populating them with electronic components. It involves the full assembly of a board into a functional circuit board. In board manufacturing, multiple PCBs are grouped on a single panel for efficient processing.

3. Coupon (PWB) - Wikipedia

   en.wikipedia.org/wiki/Coupon_(PWB)

   A coupon or test coupon is a printed circuit board (PCB) used to test the quality of a printed wiring board (PWB) fabrication process. Test coupons are fabricated on the same panel as the PWBs, typically at the edges. Coupons are then inspected to ensure proper layer alignment, electrical connectivity, and cross sectioned to inspect internal ...

4. Printed circuit board - Wikipedia

   en.wikipedia.org/wiki/Printed_circuit_board

   A printed circuit board (PCB), also called printed wiring board (PWB), is a laminated sandwich structure of conductive and insulating layers, each with a pattern of traces, planes and other features (similar to wires on a flat surface) etched from one or more sheet layers of copper laminated onto or between sheet layers of a non-conductive ...

5. Proteus Design Suite - Wikipedia

   en.wikipedia.org/wiki/Proteus_Design_Suite

   The Proteus Design Suite is a Windows application for schematic capture, simulation, and PCB (Printed Circuit Board) layout design.It can be purchased in many configurations, depending on the size of designs being produced and the requirements for microcontroller simulation.

6. Rework (electronics) - Wikipedia

   en.wikipedia.org/wiki/Rework_(electronics)

   After fabrication of the BGA package, tiny balls of solder are glued to the pads on its underside; during assembly the balled package is placed on the PCB and heated to melt the solder and, all being well, to connect each pad on the device to its mate on the PCB without any extraneous solder bridging between adjacent pads. Bad connections ...

7. In-circuit testing - Wikipedia

   en.wikipedia.org/wiki/In-circuit_testing

   A common form of in-circuit testing uses a bed-of-nails tester.This is a fixture that uses an array of spring-loaded pins known as "pogo pins". When a printed circuit board is aligned with and pressed down onto the bed-of-nails tester, the pins make electrical contact with locations on the circuit board, allowing them to be used as test points for in-circuit testing.