Ads
related to: hydraulic cylinder stroke control blocks for motorcycles for sale ebay motorswalmart.com has been visited by 1M+ users in the past month
automationdirect.com has been visited by 10K+ users in the past month
Search results
Results from the WOW.Com Content Network
S&S Cycle is an American motorcycle engine and parts engineer and manufacturer. The company was founded in 1958 by George J. Smith and Stanley Stankos in Blue Island, Illinois. [1] The company started by selling high performance pushrods for Harley-Davidson motorcycles, [2] and today they still make parts for a variety of V-Twin bikes. The ...
The Honda CB360 is a twin cylinder four-stroke motorcycle produced by Honda from 1974 to 1976. It succeeded the Honda CB350 and provided an alternative to the four cylinder CB350F and CB400F. The CB360 was a new design. The 356 cc engine was tuned for broad range torque, and drove the rear wheel through a six-speed gearbox.
A servo valve receives pressurized hydraulic fluid from a source, typically a hydraulic pump. It then transfers the fluid to a hydraulic cylinder in a closely controlled manner. Typically, the valve will move the spool proportionnaly to an electrical signal that it receives, indirectly controlling flow rate.
A hydraulic cylinder is the actuator or "motor" side of this system. The "generator" side of the hydraulic system is the hydraulic pump which delivers a fixed or regulated flow of oil to the hydraulic cylinder, to move the piston. There are three types of pump widely used: hydraulic hand pump, hydraulic air pump, and hydraulic electric pump.
The entire system, consisting of the pump, the cylinder and a reservoir of hydraulic fluid, is packaged into a single self-contained unit. Instead of the energy needed to move the controls being supplied by an external hydraulic supply, it is supplied over normal electrical wiring, albeit larger wiring than what would be found in a fly-by-wire ...
Cutaway side-view diagram of an axial piston pump 3-D rendering of an axial piston pump with the parts labeled Animation of an axial piston pump in operation. An axial piston pump has a number of pistons (usually an odd number) arranged in a circular array within a housing which is commonly referred to as a cylinder block, rotor or barrel.
Motorcycles with a V-twin engine mounted with its crankshaft mounted in line with the frame, e.g. the Honda CX series, are said to have "transverse" engines, [1] [2] while motorcycles with a V-twin mounted with its crankshaft mounted perpendicular to the frame, e.g. most Harley-Davidsons, are said to have "longitudinal" engines.
The Genesis engine first appeared on the 1985 Yamaha FZ750 and was later used on a variety of motorcycles for different kinds of markets. The design was used for parallel-twins (such as the TDM and the TRX) as well as for four-cylinder models. Both fours and twins had the cylinder block slanted forwards 45 degrees.
Ads
related to: hydraulic cylinder stroke control blocks for motorcycles for sale ebay motorswalmart.com has been visited by 1M+ users in the past month
automationdirect.com has been visited by 10K+ users in the past month