Search results
Results from the WOW.Com Content Network
When it goes wrong, it stops transmitting the signal which contains the vital data for the ignition and other parts in the system. A bad crank position sensor can worsen the way the engine idles, or the acceleration behaviour. If the engine is revved up with a bad or faulty sensor, it may cause misfiring, motor vibration or backfires.
A power-train control module, abbreviated PCM, is an automotive component, a control unit, used on motor vehicles. It is generally a combined controller consisting of the engine control unit (ECU) and the transmission control unit (TCU). On some cars, such as many Chryslers, there are multiple computers: the PCM, the TCU, and the Body Control ...
The ignition switch was designed to remove power from the vehicle's airbags when in the Off or Accessory mode. [11] Therefore, this was a safety hazard: If the switch changed from Run to Accessory and the vehicle was involved in an accident, it would no longer have power to release the airbags, and it would be difficult for the driver to steer ...
An electronic control unit (ECU), also known as an electronic control module (ECM), is an embedded system in automotive electronics that controls one or more of the electrical systems or subsystems in a car or other motor vehicle.
In automotive electronics, body control module or 'body computer' is a generic term for an electronic control unit responsible for monitoring and controlling various electronic accessories in a vehicle's body.
As batteries became more common in cars (due to the increased usage of electric starter motors), magneto systems were replaced by systems using an induction coil.The 1886 Benz Patent-Motorwagen and the 1908 Ford Model T used a trembler coil ignition system, whereby the trembler interrupted the current through the coil and caused a rapid series of sparks during each firing.
A predecessor system called "Unitized Ignition" was optional on 1972 and 1973 Pontiacs. [citation needed] Most—but not all—HEI systems have the ignition coil mounted in the distributor cap. A control module and magnetic pickup are mounted in the distributor, in place of a conventional ignition system's breaker points and condenser.
Auto reignition lowers the risk of gas leaks: if a flame goes out during operation, for example, from vibration or a gust of wind; due to misoperation—a user might not understand the "light" position must be maintained for about 0.5 to 2 seconds before turning the burner knob on fully.