Search results
Results from the WOW.Com Content Network
A crossflow head gives better performance than a Reverse-flow cylinder head (though not as good as a uniflow), but the popular explanation put forward for this — that the gases do not have to change direction and hence are moved into and out of the cylinder more efficiently — is a simplification since there is no continuous flow because of valve opening and closing.
An overhead valve engine, abbreviated (OHV) and sometimes called a pushrod engine, is a piston engine whose valves are located in the cylinder head above the combustion chamber. This contrasts with flathead (or "sidevalve") engines , where the valves were located below the combustion chamber in the engine block .
Similar to U engines, H engines consist of two separate flat engines joined by gears or chains. H engines have been produced with between 4 and 24 cylinders. An opposed-piston engine is similar to a flat engine in that pairs of pistons are co-axial but rather than sharing a crankshaft, instead share a single combustion chamber per pair of ...
A crossflow T-head sidevalve engine The usual L-head arrangement Pop-up pistons may be used to increase compression ratio Flathead with Ricardo's turbulent head. A flathead engine, also known as a sidevalve engine [1] [2] or valve-in-block engine, is an internal combustion engine with its poppet valves contained within the engine block, instead of in the cylinder head, as in an overhead valve ...
A right-hand railroad switch with point indicator pointing to right Animated diagram of a right-hand railroad switch. Rail track A divides into two: track B (the straight track) and track C (the diverging track); note that the green line represents direction of travel only, the black lines represent fixed portions of track, and the red lines depict the moving components.
A cylinder head of a four valve Nissan VQ engine engine. A multi-valve or multivalve engine is one where each cylinder has more than two valves (an intake, and an exhaust).A multi-valve engine has better breathing, and with more smaller valves (having less mass in motion) may be able to operate at higher revolutions per minute (RPM) than a two-valve engine, delivering more power.
Cutaway of a dual overhead camshaft engine 1969 AMC V8 overhead valve engine. The rocker cover has been removed, so elements of the pushrods, rocker arms, valve springs, and valves are visible. A valvetrain is a mechanical system that controls the operation of the intake and exhaust valves in an internal combustion engine. [1]
The 3.5 L; 214.7 cu in (3,518 cc) engine was a version of the 3.3 with a larger bore of 96 mm (3.78 in) and featured overhead cams. The 3.5L version has an intake arrangement with two separate manifolds and throttle bodies connected with a crossover valve. This provides better low and midrange torque.