enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. List of battery sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_battery_sizes

   4.5 + 4.5: H: 91.3 L: 65.1 W: 52.4 This battery contained two independent 4.5 V batteries, and had a four-pin connector. 9 V with a center tap was available by wiring in series. There were two ⌀3.2 mm negative pins spaced 9.5 mm apart and two ⌀4.0 mm positive pins spaced 14.3 mm apart. Negative and positive pins were spaced 18.1 mm apart.

3. Safety data sheet - Wikipedia

   en.wikipedia.org/wiki/Safety_data_sheet

   An example SDS, including guidance for handling a hazardous substance and information on its composition and properties. A safety data sheet (SDS), [1] material safety data sheet (MSDS), or product safety data sheet (PSDS) is a document that lists information relating to occupational safety and health for the use of various substances and products.

4. Sodium dodecyl sulfate - Wikipedia

   en.wikipedia.org/wiki/Sodium_dodecyl_sulfate

   Sodium dodecyl sulfate (SDS) or sodium lauryl sulfate (SLS), sometimes written sodium laurilsulfate, is an organic compound with the formula CH 3 (CH 2) 11 OSO 3 Na and structure H 3 C−(CH 2) 11 −O−S(=O) 2 −O − Na +. It is an anionic surfactant used in many cleaning and hygiene products. This compound is the sodium salt of the 12 ...

5. SDS - Wikipedia

   en.wikipedia.org/wiki/SDS

   Slotted Drive Shaft, a special shank on a hammer drill bit; see Rotary hammer § Special chuck; Software-defined storage, a marketing term for data storage; Special Direct System, a drill bit fixing system; Spoken dialog systems, technology allowing machines to converse with humans based on human voice and language

6. Drill bit sizes - Wikipedia

   en.wikipedia.org/wiki/Drill_bit_sizes

   So a 1 / 2 in (12.7 mm) diameter drill will be able to drill a hole 4 + 1 / 2 in (114.3 mm) deep, since it is 9 times the diameter in length. A 1 / 8 in (3.175 mm) diameter drill can drill a hole 1 + 5 / 8 in (41.275 mm) deep, since it is 13 times the diameter in flute length. [3]

7. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   A good tap drill is 85% (± 2 pp) of major diameter for coarse threads, and 90% (± 2 pp) of major diameter for fine threads. [ 1 ] For metric V threads , the concept of major minus pitch (i.e., the major or widest diameter of the intended screw in millimeters minus the pitch of the threads of that screw in millimeters per thread) yields a good ...