Search results
Results from the WOW.Com Content Network
Usually, four guide pillars and guide bushes are used, out of which three pillars are of one diameter and one is of a different diameter, to force the plates into a single configuration (based on the "POKE YOKE" [mistake proof] concept). The register ring has interference fit in top plate and transmission fit with the injection molding machine ...
Bed-mould or bed moulding: Narrow moulding used at the junction of a wall and ceiling, found under the cornice, of which it is a part. [2] Similar to crown moulding, a bed mould is used to cover the joint between the ceiling and wall. Bed moulds can be either sprung or plain, or flush to the wall as an extension of a cornice mould. [3]
This projected area is multiplied by a clamp force of from 1.8 to 7.2 tons for each square centimetre of the projected areas. As a rule of thumb, 4 or 5 tons/in 2 can be used for most products. If the plastic material is very stiff, it requires more injection pressure to fill the mould, and thus more clamp tonnage to hold the mould closed.
Compression molding is a method of molding in which the molding material, generally preheated, is first placed in an open, heated mold cavity. The mold is closed with a top force or plug member, pressure is applied to force the material into contact with all mold areas, while heat and pressure are maintained until the molding material has cured; this process is known as compression molding ...
A baseboard differs from a wainscot; a wainscot typically covers from the floor to around 1-1.5 metres (3' to 5') high (waist or chest height), whereas a baseboard is typically under 0.2 metres (8") high (ankle height). Plastic baseboard comes in various plastic compounds, the most common of which is UPVC.
The mixing is done at room temperature and stored at low temperatures to slow down curing prior to molding. The concentration of the mixture can vary depending on application, but is typically 30% glass fibers, 25% filler, and 45% resin, styrene, and initiator. [2] The material is provided in bulk or in logs approximately 4" in diameter.
Illustrations of cornices in different styles Illustrations of various examples of ancient Egyptian cornices, all of them having cavettos. In architecture, a cornice (from the Italian cornice meaning "ledge" [1]) is generally any horizontal decorative moulding that crowns a building or furniture element—for example, the cornice over a door or window, around the top edge of a pedestal, or ...
A building's surface detailing, inside and outside, often includes decorative moulding, and these often contain ogee-shaped profiles—consisting (from low to high) of a concave arc flowing into a convex arc, with vertical ends; if the lower curve is convex and higher one concave, this is known as a Roman ogee, although frequently the terms are used interchangeably and for a variety of other ...