enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Roman numerals - Wikipedia

    en.wikipedia.org/wiki/Roman_numerals

    Notation for fractions other than 1 ⁄ 2 is mainly found on surviving Roman coins, many of which had values that were duodecimal fractions of the unit as. Fractions less than 1 ⁄ 2 are indicated by a dot ( · ) for each uncia "twelfth", the source of the English words inch and ounce ; dots are repeated for fractions up to five twelfths.

  3. Specific modulus - Wikipedia

    en.wikipedia.org/wiki/Specific_modulus

    Specific modulus is a materials property consisting of the elastic modulus per mass density of a material. It is also known as the stiffness to weight ratio or specific stiffness.

  4. f-number - Wikipedia

    en.wikipedia.org/wiki/F-number

    The f-number N is given by: = where f is the focal length, and D is the diameter of the entrance pupil (effective aperture).It is customary to write f-numbers preceded by "f /", which forms a mathematical expression of the entrance pupil's diameter in terms of f and N. [1]

  5. HP 35s - Wikipedia

    en.wikipedia.org/wiki/HP_35s

    Entry of mixed fractions involves using decimal points to separate the parts. For example, the sequence 3. 1 5. 1 6 →cm converts 3 + 15 ⁄ 16 inches to 10.0 cm (approximately). The calculator may be set to automatically display values as mixed fractions by toggling the FDISP key. The maximum denominator may be specified using the /c function.

  6. Addition - Wikipedia

    en.wikipedia.org/wiki/Addition

    Near-doubles: Sums such as 6 + 7 = 13 can be quickly derived from the doubles fact 6 + 6 = 12 by adding one more, or from 7 + 7 = 14 but subtracting one. [36] Five and ten: Sums of the form 5 + x and 10 + x are usually memorized early and can be used for deriving other facts. For example, 6 + 7 = 13 can be derived from 5 + 7 = 12 by adding one ...

  7. Machine taper - Wikipedia

    en.wikipedia.org/wiki/Machine_taper

    The rate of taper is 1:20 on diameter, in other words 0.600" on diameter per foot, .050" on diameter per inch. Tapers range from a Number 2 to a Number 20. The diameter of the big end in inches is always the taper size divided by 8, the small end is always the taper size divided by 10 and the length is the taper size divided by 2.

  8. Approximations of π - Wikipedia

    en.wikipedia.org/wiki/Approximations_of_π

    The latter fraction is the best possible rational approximation of π using fewer than five decimal digits in the numerator and denominator. Zu Chongzhi's results surpass the accuracy reached in Hellenistic mathematics, and would remain without improvement for close to a millennium.

  9. Slash (punctuation) - Wikipedia

    en.wikipedia.org/wiki/Slash_(punctuation)

    This notation is known as an online, solidus, [21] or shilling fraction. [21] Nowadays fractions, unlike inline division, are often given using smaller numbers, superscript , and subscript (e.g., 23 / 43 ).